Abstract:Although end-bearing energy pile foundations subjected to symmetrical thermal cycles have been extensively studied in the laboratory and in the field, the mechanisms underlying the thermo-hydro-mechanical (THM) interactions in floating energy pile groups and rafts, especially when subjected to asymmetrical thermal loads, are not well understood. In this study, an advanced thermo-mechanical bounding surface model was implemented in finite-element (FE) code to investigate the THM interactions of a two-by-two floating energy pile group and pile raft, focusing on asymmetrical thermal cycles. Computed results are compared with published centrifuge model test results in soft clay. It is revealed that the irreversible volumetric contraction of the soil adjacent to the energy piles accumulates with each thermal cycle, resulting in a decrease in the horizontal stress and hence shaft resistance of the floating piles. During thermal cycles, the stress states of the soil around the energy pile shaft and the soil beneath the pile toe approach the critical state line along different paths. The induced temperature in the soil adjacent to the non-energy pile (NEP) is 5°C lower than that in the soil at the energy pile EP1, which is flanked by the other two energy piles EP2 and EP3. Consequently, the induced excess pore pressure in the soil at the NEP is approximately 20% smaller than that in the soil at EP1. The irreversible volumetric soil contraction at the NEP is about half that at EP1, resulting in approximately 45% less toe settlement. The thermally induced ratcheting settlements of the head and toe of the NEP are less than those of the energy piles, resulting in unacceptable ratcheting tilting of the floating energy pile group. However, the excessive tilting can be reduced by the use of a pile raft.

A simple load transfer method for energy pile groups

Model Test Study of Bearing Behavior of Small Prefabricated Piles in Soft Soil Area

A New Method for Analyzing the Thermomechanical Behavior and the Null Point Movement of Energy Piles

A simple method for analyzing thermomechanical response of an energy pile in a group

FEM Analysis and Simplified Approach for a Single Energy Pile Subjected to Thermomechanical Loads

Analysis method for pile groups subjected to lateral and torsional loads

Load Transfer of Offshore Open-Ended Pipe Piles Considering the Effect of Soil Plugging

Model Test on Load Transfer Mechanism of a Static Drill Rooted Nodular Pile

An Elasto-Plastic Numerical Analysis of THM Responses of Floating Energy Pile Foundations Subjected to Asymmetrical Thermal Cycles

Lateral Dynamic Responses of Coastal Group Piles Considering Pile‒water‒soil Interactions

Numerical investigations on effects of mechanical and geometrical characteristics on thermally induced group behavior of field-scale energy piles

Load Transfer Rule of Composite Ground under Flexible Foundation

Analytical solutions for thermal–mechanical coupling of energy piles in double-layer soil

Evaluation of the group efficiency factor for laterally loaded pile groups

A Simple Method for Predicting the Response of Single Energy Pile Considering Temperature Variation of Pile–Soil Interface

Load transfer of the disconnected pile

The mechanical response of energy pile groups in layered cross-anisotropic soils under vertical loadings

Influence of end conditions on load transfer behavior of cast-in-place piles

Thermally induced mechanical interactions of energy pile groups subjected to cyclic nonsymmetrical thermal loading

A Study on the Softening Shear Model of the Energy Pile–Soil Contact Surface