Aircraft observations of aerosol and BC during the East Asian dust storm event: Vertical profiles, size distribution and mixing state
Xingguang Liu,Delong Zhao,Zhongqing Niu,Guangna Zhao,Deping Ding,Yi Chen,Haotian Liu
DOI: https://doi.org/10.1016/j.atmosenv.2024.120492
IF: 5
2024-04-03
Atmospheric Environment
Abstract:The vertical structure of meteorological elements, black carbon (BC), and aerosols were in situ characterized by the King Air 350 aircraft measurements over the northeast of China during an East Asian dust storm event from April 10 to 13, 2023. The main causes of this dust storm event were the strong winds generated by the Mongolian cyclone, the cold front on the ground provided dynamic conditions, and the unstable atmospheric state provided thermal conditions and less precipitation in the dust source areas led to exposed the ground surface. The number concentrations of BC and aerosol had significant vertical distribution. The number concentration of aerosol in the dust storm (DS) layer increased rapidly with height, while the number and mass concentrations of BC were higher and varied slightly with height. The BC core mass median diameters (MMD) first increased with height, reaching a maximum value of 0.24μm at 3000m; and it rapidly decreased to 0.18μm at 3200m and then varied slightly with height above 3200m. BC's bulk relative coating thickness (coated diameter divided by uncoated core diameter Dp/Dc) first decreased with height, reaching a minimum value of 1.16 at 3000m, then increased with height, reaching a maximum of 1.38 (4250m). A wind shear layer (7.9 m·s −1 at 1850 m) with a sudden drop in temperature (the cooling rate can reach 7.4 °C·(100 m) −1 ) at 1900 m hinders the transportation of dust particles to the ground, allowing the dust particles to be transported at long-term distances. There were two stratifications in the dust storm layer: DS1 (1700–3000 m, the vertical wind speed was downward, the horizontal wind speed was small) and DS2 (3000–4500 m, the vertical wind speed was upward, the horizontal wind speed was large). The distinct atmospheric flow field conditions between DS1 and DS2 led to different BC and aerosol pollution characteristics. In DS2, the number concentrations of BC and aerosol were higher, the aging ratio of BC particles was higher, and the size of the core particle of BC was smaller. The concentrations of BC, aerosol, Dp/Dc, and MMD in DS2 were 1.1, 59.0, 1.02, and 0.84 times higher than those in DS1, respectively. Dust particles transported over long distances were primarily small. The number concentrations of aerosols at 0.1–0.12 μm and 0.1–0.24 μm were higher in DS1 and DS2, respectively. Still, the number concentration of aerosol at 0.12–0.28 μm in DS1 was lower than in the planetary boundary layer (PBL) and residual layer (RL).
environmental sciences,meteorology & atmospheric sciences