Abstract:To accommodate the integration of renewable energy, coal-fired power plants must take on the task of peak regulation, making the low-load operation of boilers increasingly routine. Under low-load conditions, the phase transition point (PTP) of the working fluid fluctuates, leading to potential flow instability, which can compromise boiler safety. In this paper, a one-dimensional coupled dynamic model of the combustion and hydrodynamics of a supercritical boiler is developed on the Modelica/Dymola 2022 platform. The spatial distribution of key thermal parameters in the furnace and the PTP position in the water-cooled wall (WCW) are analyzed in a 660 MW supercritical boiler when parameters on the combustion side change under full-load and low-load conditions. The dynamic response characteristics of the temperature, mass flow rate, and the PTP position are investigated. The results show that the over-fire air (OFA) ratio significantly influences the flue gas temperature distribution. A lower OFA ratio increases the flue gas temperature in the burner zone but reduces it at the furnace exit. The lower OFA ratio leads to a higher fluid temperature and shortens the length of the evaporation section. The temperature difference in the WCW outlet fluid between the 20% and 60% OFA ratios is 11.7 °C under BMCR conditions and 7.4 °C under 50% THA conditions. Under the BMCR and 50% THA conditions, a 5% increase in the coal caloric value raises the flue gas outlet temperature by 32.7 °C and 35.4 °C and the fluid outlet temperature by 6.5 °C and 9.9 °C, respectively. An increase in the coal calorific value reduces the length of the evaporation section. The changes in the length of the evaporation section are −2.95 m, 2.95 m, −2.62 m, and 0.54 m when the coal feeding rate, feedwater flow rate, feedwater temperature, and air supply rate are increased by 5%, respectively.

Flue Gas Circulating Modeling of Oxy-fuel Combustion Boiler and the Volume Change Characteristics of the Flue Gas Components

Numerical investigation on oxy-combustion characteristics of a 200MW e tangentially fired boiler

Study on coal combustion characteristics in a 350MW supercritical tangentially boiler

Study on Energy Efficiency of 35mwth Oxygen-fuel Boiler with Recirculated Flue Gas

Numerical Simulation of O2／CO2 Recycled Flue Gas Combustion in a 300 MW Boiler

Decoupling Investigation of Furnace Side and Evaporation System in a Pulverized-Coal Oxy-Fuel Combustion Boiler

Off Design Performance Analysis of 35mwth Oxygen-fuel Combustion Boiler

Mathematical modeling of combustion in a grate-fired boiler burning straw and effect of operating conditions under air- and oxygen-enriched atmospheres

Numerical Study on Combustion and Heat Transfer Properties under Oxy-fuel Condition in a 600MW Utility Boiler

Numerical Simulation of the Effect of Combustion Process on Flue Gas Thermal Deviation in 660MW Boiler

Study on Carbon Dioxide Enrichment Capacity of 35mwth Boiler Operated in 02/C02 Atmosphere with Recirculated Flue Gas

A Dynamic Heat Transfer Model to Estimate the Flue Gas Temperature in the Horizontal Flue of the Coal-Fired Utility Boiler

Combustion Modeling Of Cfb Boiler Furnace Based On An Euler-Euler Approach

A Comprehensive CFD Combustion Model for Supercritical CFB Boilers

Effects of flue gas recirculation on combustion and heat flux distribution in 660 MW double-reheat tower-type boiler

Coupled Modeling of Combustion and Heat Transfer Process of a Supercritical CO2 Boiler

Simulation of Dynamic Characteristics of Supercritical Boiler Based on Coupling Model of Combustion and Hydrodynamics

Influence of gas composition and properties on the combustion and heat transfer characteristics of pulverized oxy-coal boiler

Experimental and Modeling Studies on Sulfur Trioxide of Flue Gas in a Coal-Fired Boiler

Numerical investigations on the aerodynamics and flue gas recirculation of cyclone-fired coal boiler

Modeling of NOx emissions from a W-shaped boiler furnace under different operating conditions