Abstract:Resistance Rivet Spot Welding (RRSW) is a joining technique with high flexibility and cost efficiency for connecting steel and aluminum sheet metal parts in an automotive body in white (BIW). Using this method, both pure steel and steel-aluminum mixed BIW can be produced in the same assembly line. The prediction of the load-bearing capacity and failure behavior in crashworthiness calculation by the OEMs requires a stable finite element (FE) simulation model for both static and dynamic load cases. In this paper, an experimental and numerical study on the behavior of RRSW connections is presented. After the analysis of different material models with varying FE codes, the material model MAT 100DA of LS-DYNA was chosen as the starting point for crash simulation. For the determination of the model parameters as well as the entire FE model, material tests with different strain rates and KS-II-tests with three different velocities were performed. The FEM parameters were determinedviaiterative parameter calibration. Lap shear, peeling, and component tests were conducted for parameter validation along with the FE calculations. In the experiment, the loading rate-dependent behavior of the RRSW joining was observed in terms of force-displacement curves and the failure phenomenon. The simulation's results show that the performance of vehicle components joined by RRSW are predicable by using the material model MAT_100DA. The prediction of failure behavior can be further improved by using a detailed meso-scale model.

A Study on the Finite Element Modeling for Spot-welds of Vehicle Body

FEM analysis of spot welding process in autobody manufacturing

Fatigue Life Analysis of Car Body Structure and Spot Weld Based on FEM

Studies on a computational model and the stress field characteristics of weld-bonded joints for a car body steel sheet

Failure Behavior and Crash Modelling of Resistance Rivet Spot Welding (RRSW) for Joining Al and Steel in Vehicle Structure

A Simplified Spot Weld Model for Finite Element Analysis

Comparison of FEA for Beam and Shell Element Models of Integral Bus Body Frame

Finite Element Analysis on the Lateral Crashworthiness of Car Body Structure

The Finite Element Analysis of a Minibus's BIW

Numerical simulation and analysis of welding of drive axle housing and axle tube

Spot Weld Fatigue Life Prediction of Commercial Vehicle Cab

Numerical Analysis on Welding Deformation and Residual Stress of an Aluminum Alloy Floor of EMU Bodywork

Development of resistance spot welding material card for dissimilar automobile plates

Impact Modeling of the Weld Line of Tailor-Welded Blank

Finite Element Analysis on the Rear Axle Housing of Vehicle

Crashworthiness Simulation and Improvement Design of Auto-Body Based on Finite Element Mehtod

Stiffness and strength numerical analysis of car body joint

A simplified FE model for pull-out failure of spot welds

Reliability Analysis and Evaluation of Automobile Welding Structure

3-D Numerical Simulation of Driving Force of Weld Solidification Cracking in Stainless Steel Thick Plate