Abstract:BackgroundThe rapid, simple determination of surfactants in environmental samples is essential because of the extensive use and its potential as contaminants. We describe a simple, rapid chemiluminescence method for the direct determination of the non-ionic surfactant Triton X-100 (polyethylene glycol tert-octylphenyl ether) in environmental water samples. The optimized experimental conditions were selected, and the mechanism of the Luminol-H2O2-Triton X-100 chemiluminesence system was also studied.ResultsThe novel chemiluminescence method for the determination of non-ionic surfactant Triton X-100 was based on the phenomenon that Triton X-100 greatly enhanced the CL signal of the luminol-H2O2 system. The alkaline medium of luminol and the pH value obviously affected the results. Luminol concentration and hydrogen peroxide concentration also affected the results. The optimal conditions were: Na2CO3 being the medium, pH value 12.5, luminol concentration 1.0 × 10-4 mol L-1, H2O2 concentration 0.4 mol L-1. The possible mechanism was studied and proposed.ConclusionUnder the optimal conditions, the standard curve was drawn up and quotas were evaluated. The linear range was 2 × 10-4 g·mL-1-4 × 10-2 g·mL-1 (w/v), and the detection limit was 3.97 × 10-5 g·mL-1 Triton X-100 (w/v). The relative standard deviation was less than 4.73% for 2 × 10-2 g·mL-1 (w/v) Triton X-100 (n = 7). This method has been applied to the determination of Triton X-100 in environmental water samples. The desirable recovery ratio was between 96%–102% and the relative standard deviation was 2.5%–3.3%. The luminescence mechanism was also discussed in detail based on the fluorescence spectrum and the kinetic curve, and demonstrated that Triton X-100-luminol-H2O2 was a rapid reaction.

Cloud point of nonionic surfactant Triton X-45 in aqueous solution.

Cloud point system as a tool to improve the efficiency of biotransformation

Nonionic Surfactant Mediated Cloud Point Extraction

Phase separation, aggregation, and complexation of triton-X100 and bovine serum albumin mixture: A combined cloud point and UV-visible spectroscopic approaches

Two cloud-point phenomena in tetrabutylammonium perfluorooctanoate aqueous solutions: anomalous temperature-induced phase and structure transitions.

Physicochemical investigations of clouding development and physicochemical properties of Triton X-100 and levofloxacin hemihydrate mixture: influence of sodium salts composition

Determination of solubilization of phenol at coacervate phase of cloud point extraction

Liquid–Liquid Equilibrium of Aqueous Two-Phase Systems Formed by Nonionic Surfactants (Triton X-100, Triton X-165, or Triton X-305), Salts (NaNO 3 or KNO 3 ), and Water at Different Temperatures

Effect of Concentrations of Additives on the Cloud Point of Nonionic Surfactant AEO9

Extractive Whole Cell Biotransformation In Cloud Point System

Analysis of Non-Ionic Surfactant Triton X-100 Using Hydrophilic Interaction Liquid Chromatography and Mass Spectrometry

Surfactant Distribution in the Clouding of TX114

Double Cloud Point of Ethylene Oxide–propylene Oxide Triblock Copolymer in an Aqueous Solution

Cloud Point Extraction and Separation of Scandium and Yttrium (III) with Triton X‐114 in the Presence or Absence 8‐Hydroquiloline as an Added Chelate

Influence of Polyol/Salt Additives on the Drug-Mediated Phase Separation and Thermodynamic Properties of Triton X-100

Whole Cell Microbial Transformation in Cloud Point System

Solubility of ionic surfactants below their Krafft point in mixed micellar solutions: Phase diagrams for methyl ester sulfonates and nonionic cosurfactants

Interfacial Tension of Aqueous Three‐Phase Systems Formed by Triton X‐100/PEG/Dextran

Chemiluminescence determination of surfactant Triton X-100 in environmental water with luminol-hydrogen peroxide system

Surface Properties and Aggregates in the Mixed Systems of Bolaamphiphiles and Their Oppositely Charged Conventional Surfactants