Domain Wall Dynamics and Barkhausen Jumps in Thin-Film Permalloy Microstructures

SQ Yang,JL Erskine

DOI: https://doi.org/10.1103/physrevb.72.064433

IF: 3.7

2005-01-01

Physical Review B

Abstract:Domain wall jump-amplitude and velocity distributions associated with Barkhausen jumps in a 300-A-thick thin-film permalloy and a 200x200 (mu m)(2)x220-A-thick permalloy sample microstructrue are measured using a high-speed magneto-optic Kerr effect polarimeter. The jump-amplitude and velocity distributions are obtained for applied-field sweep rates from 0.9 Oe/s to 6.3x10(4) Oe/s. The velocity distributions exhibit statistical properties consistent with the stochastic description of field-driven domain wall motion developed by ABBM [B. Alessandro, C. Beatrice, G. Bertotti, and A. Montorsi, J. Appl. Phys. 68, 2901 (1990)]. Averaged velocity distributions exhibit the expected increase of dynamic coercivity as the sweep rate is increased, and the maximum domain wall velocity measured as a function of the applied field at the stochastic depinning threshold is shown to be governed by the mobility limit imposed by local spin damping. The averaged velocity < v(H-H-0)> obtained from the distributions is observed to depart from the commonly accepted linear-dependence model, especially at higher drive-field sweep rates. This departure is interpreted as an indication of a sweep-rate-dependent mobility. Sweep-rate-dependent jump-amplitude distributions P(Delta M) versus Delta M are obtained from the Barkhausen effect data. These distributions exhibit power-law behavior with a sharp cutoff at large values of Delta M. Attempts to reconcile the measured jump-amplitude distributions and sweep-rate-dependent exponents with various models of universal scaling are described. Power-law fits to P(Delta M) distributions measured to optimize temporal resolution (required for the velocity-distribution studies) yield a sweep-rate-dependent exponent that varies from beta=1.45 +/- 0.05 to beta=1.0 as dH/dt is varied from 25 Oe/s to 6.3x10(4) Oe/s. This range of sweep-rate-dependent beta agrees with the ABBM model and is consistent with the sweep-rate dependence exponent rule that predicts linear sweep-rate scaling for the adiabatic value beta=3/2 [R. A. White and K. A. Dahmen, Phys. Rev. Lett. 91, 085702 (2003)]. Additional experiments on both 300-A-thick continuous films and the same microstructures optimized for Delta M sensitivity yield a more accurate value of beta (beta=1.33 +/- 0.01), which corresponds to a CZDS model (beta=4/3) [C. Cizeau, S. Zapperi, G. Durin, and H. E. Stanley, Phys. Rev. Lett. 79, 4669 (1997); Phys. Rev. B 58, 6353 (1998)]. Adiabatic limit values of beta determined from all of the experiments are definitively outside the range beta similar to 1.0 for self-organized criticality in a two-dimensional system [P. Bak, C. Tang, and K. Wiesenfeld, Phys. Rev. Lett. 59, 381 (1987)], and also appear to be inconsistent with experimental results for 900 A Fe films on MgO in which beta=1.1 was obtained from rescaled P(Delta M) distributions [E. Puppin, Phys. Rev. Lett. 84, 5415 (2000)]. The sweep-rate dependence of beta determined in a system that manifests an adiabatic limit of beta that is not equal to 3/2 also violates the model of White and Dahman that prohibits sweep-rate-dependent scaling for beta=4/3.