The Effect of Water Content on the Ultimate Properties of Rubbery Nanocomposite Gels

Kazutoshi Haraguchi,Huan-Jun Li
DOI: https://doi.org/10.1002/polb.21829
2009-01-01
Abstract:An investigation was conducted into the effects of water content (R-H2O) on the ultimate tensile properties of nanocomposite hydrogels (NC gels) based on poly(N-isopropylacrylamide)/clay networks. Rubbery NC gels with low clay contents (<NC10) exhibited unique changes in their stress-strain curves, depending on the R-H2O. At high R-H2O, where PNIPA chains are fully hydrated, NC gels retained their rubbery tensile properties, whereas they changed to exhibit plastic-like deformations with decreasing R-H2O. Consequently, for a series of NC gels with different R-H2O, a failure envelope was obtained by connecting the rupture points in the stress-strain curves. Here, the counterclockwise movement was observed as either the R-H2O decreased or the strain rate increased. This seemed to be analogous to that of a conventional elastomer (e.g., SBR), although the mechanisms are different in the two cases. From the R-H2O and C-clay dependences of the ultimate properties, three critical values of R-H2O were defined, where R-H2O showed a maximum strain at break, a steep increase in initial modulus, and onset of brittle fracture. Compared with NC gels, OR gels (chemically crosslinked hydrogels) showed similar but very small changes in their stress-strain curves on altering R-H2O, whereas LR (viscous PNIPA solution) showed a monotonic decrease (increase) in epsilon(b) (E-i) with decreasing R-H2O. (C) 2009 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 47: 2328-2340, 2009
What problem does this paper attempt to address?