Abstract:A novel stationary phase for high performance liquid chromatography was prepared using urushiol methacrylate as the chromatographic ligand. The mixed urushiol methacrylate was prepared using urushiol and methacryloyl chloride via a substitution reaction and then coated onto the surface of spherical silica by physical adsorption. The spherical silica was chemically modified with 3-methacryloyloxypropyl trimethoxysilane. Then, the urushiol methacrylate-bonded silica stationary phase (USP) was synthesized via the surface radical polymerization of urushiol methacrylate and the pendant vinyl groups onto the surface of the spherical silica. The stationary phase was characterized by Fourier transform infrared spectroscopy, thermogravimetric analysis, scanning electron microscopy, and elemental analysis. The results revealed that the urushiol methacrylate was successfully immobilized on the spherical silica surface after the surface polymerization reaction, and that it had excellent monodispersity. The stationary phases were packed in a stainless-steel hollow column by the slurry packing method, with methanol as the slurry solvent and absolute ethanol as the propelling solvent. The chromatographic performance of the stationary phases were investigated for the separation of Gastrodia elata extract. Acetonitrile-0.05% phosphoric acid solution (3:97, v/v) was employed as the mobile phase at a flow rate of 0.4 mL/min, with the detection wavelength of 220 nm. The separation performance for Fructus evodia extract was also studied, using acetonitrile-water (50:50, v/v) as the mobile phase at a flow rate of 0.5 mL/min, and the detection wavelength was 290 nm. This column showed good separation performance for both these extracts. Out of the five peaks observed for the Gastrodia elata extract, one was attributed to gastrodin, but the other four peaks need to be further verified. Two peaks assignable to evodiamine and rutaecarpine were observed for the Fructus evodia extract. Compared with C18 column, the USP column allowed for more effective separation of the components from the Gastrodia elata extract, with baseline separation; on the other hand, the chromatographic conditions for the separation of the components of the Fructus evodia extract were more environmentally friendly and safer. Because of the low flow rates adopted for the separation of the Gastrodia elata and Fructus evodia extracts, the amount of mobile phase used could be reduced. This study provides not only a new method for the separation and purification of gastrodin and evodiamine in real samples, but also a new strategy for the preparation of chromatographic stationary phases. It expanded the application of raw lacquer in chromatographic separation materials.

Matrine-Imprinted Monolithic Stationary Phase for Extraction and Purification of Matrine from Sophorae Flavescentis Ait

Preparative separation and determination of matrine from the Chinese medicinal plant Sophora flavescens Ait by molecularly imprinted solid-phase extraction

Fabrication of sulfonated cellulose nanocrystals/sodium alginate beads for adsorbents of matrine

Magnetic Molecularly Imprinted Polymer Combined with Solid-Phase Extraction for Purification of Schisandra chinensis Lignans

Preparation of Monoethyl Fumarate-Based Molecularly Imprinted Polymers and Their Application As a Solid-Phase Extraction Sorbent for the Separation of Scopolamine from Tropane Alkaloids.

Preparation of Molecularly Imprinted Foam for Selective Extraction of Toxic Monocrotaline from Herbs

Semi-Preparative Scale Separation of Emodin from Plant Extract by Using Molecularly Imprinted Polymer as Stationary Phase

Selective Extraction of Functional Components Derived from Herb in Plasma by Using a Molecularly Imprinted Polymer Based on 2,2-Bis(hydroxymethyl)butanol Trimethacrylate.

Surface-initiated Molecularly Imprinted Polymeric Column: in Situ Synthesis and Application for Semi-Preparative Separation by High Performance Liquid Chromatography.

Isolation and Purification of Matrine and Oxymatrine and TLC Identification of Radix Sophorae Tonkinensis

Fabrication and application of molecularly imprinted polymer doped carbon dots coated silica stationary phase

Molecularly Imprinted Solid Phase Extraction Using Bismethacryloyl-β-cyclodextrin and Methacrylic Acid As Double Functional Monomers for Selective Analysis of Glycyrrhizic Acid in Aqueous Media

Magnetic Solid-phase Extraction with Fe3O4/Molecularly Imprinted Polymers Modified by Deep Eutectic Solvents and Ionic Liquids for the Rapid Purification of Alkaloid Isomers (Theobromine and Theophylline) from Green Tea

Molecularly imprinted polymer for the specific solid-phase extraction of kirenol from Siegesbeckia pubescens herbal extract

[Preparation and application of urushiol methacrylate-bonded silica liquid chromatographic stationary phase]

Exploration of a ternary deep eutectic solvent of methyltriphenylphosphonium bromide/chalcone/formic acid for the selective recognition of rutin and quercetin in Herba Artemisiae Scopariae

Concentration and Extraction of Sinomenine from Herb and Plasma Using a Molecularly Imprinted Polymer As the Stationary Phase

Extracting Active Compounds from Herbs Using Molecular Imprinting Technology

Preparation and Recognition Properties of Molecularly Imprinted Nanofiber Membrane of Chrysin

Role of competitive effect in the separation mechanism of matrine and oxymatrine using commercial NF membranes

Separation and Enrichment of Trace Ractopamine in Biological Samples by Uniformly-Sized Molecularly Imprinted Polymers.