Abstract:With the wide application potential of wrought aluminium alloy in aerospace, automobile and electronic products, high-quality aluminium bars prepared by the radial forging (RF) process have received extensive attention. Penetration performance refers to the depth of radial plastic deformation of forgings, which is the key factor in determining the quality of forging. In this work, the penetration performance of the radial forging process for 6063 wrought aluminium bars is investigated by simulation using FORGE software. The minimum reduction amount of the hammer is calculated based on the forging penetration theory of forging. The influence of process parameters including forging ratio (FR) and billet temperature on the effective stress and hammer load in the RF process are investigated. The RF-deformed billet is then produced with the optimal process parameters obtained from the simulation results. The average grain size of aluminium alloy semi-solid spherical material is used to evaluate the forging penetration. Simulation results showed that the effective strain at the edge and the centre of the RF-deformed billet gradually increases, but the increasing speed of the effective strain at the edge becomes low. The hammer load first decreases quickly and then gradually maintains stability by increasing the FR. It is found that low billet temperature and high FR should be selected as appropriate process parameters under the allowable tonnage range of RF equipment. Under an isothermal temperature of 630 °C and a sustaining time of 10 min, the difference in the average grain dimension between the edge and the centre positions of the starting extruded blank is 186.43 μm, while the difference in the average grain dimension between the edge and the centre positions of the RF-deformed blank is 15.09 μm. The improvement ratio of penetration performance for the RF-deformed blank is obtained as 91.19%.

Precision Design and Improvement of Forging Technology of V26-1 Aluminum Alloy Piston

Billets Study During Piston Skirt Forging Process of LD11 Aluminium Alloy

Analysis of Die Forging Process and FEA of Piston

Study on Precision Forging Technology for A Complex-Shaped Light Alloy Forging

Digital Design of Isothermal Precision Forming of Complex Disk Forging

Precision machining of an aluminum alloy piston reinforced with a cast iron insert

Numerical Simulation of Pre-forging for Connecting Rod of Automobile Engine and Optimization of Its Pre-forging Billet

Isothermal precision forging of complex-shape rotating disk of aluminum alloy based on processing map and digitized technology

Study on isothermal precision forging process of an aluminum alloy ring seat

Process Design Based on Fe Simulations and Experiments of Forging A Complex-Shaped Magnesium Alloy Adaptor

Investigation on hollow steel ingot forging process of heavy cylinder forging

Experimental Study on Process of Precision Forging of an Aluminium-Alloy Rotor

A Double Control Forming Technology Combining Die Casting and Forging for the Production of Mg Alloy Components with Enhanced Properties

Study on isothermal precision forging technology for a cylindrical aluminium-alloy housing

Precision Forging Technology and Equipment for Aluminum Alloy

Research and Application of Precision Forging Forming Process for Flat Thin Flash of Automobile Disc Steering Knuckle

Preparation of Aluminum Alloy Impeller by Semi-Solid Precision Forging

Investigation of the Penetration Performance of the Radial Forging Process for Wrought Aluminium Alloy

Effect of Process Parameters on the Mechanical Properties and Microstructure of Large-Sized Aluminum Alloy Parts with Complex Shape Formed by Squeeze Casting

Isothermal precision forging process of aluminum alloy cylindrical housing

Research and Application of High Precision Machining Technology for Super-Large Integral Frame Parts of Aluminum Alloy