Abstract:In this paper, a conceptual investigation of the interface between wireless power devices and a retina complementary metal oxide semiconductor (CMOS) neuron integrated circuit (IC) have been presented. The proposed investigation consists of three designs: design-I, design-II, and design-III. Design-I involves a slotted loop monopole antenna as per American National Standards Institute (ANSI) guidelines, which achieve an ultra-wide band ranging from 3.1 GHz to 10.6 GHz. The biocompatible antenna is made on silicon-nitride substrate using on-wafer packaging technology and it is used as a receiver device. The performance of antenna provides a wideband, sufficient power to receive, and low losses due to the avoidance of printed circuit board (PCB) fabrication. A CMOS based multi-stack power harvesting circuit achieves the output power ranging from 4 mW to 2.7 W and corresponds from the selected Radio Frequency (RF) bands of loop antenna is exhibited in design-II. The power efficiency of 40% to 82%, with respect to output powers of 4 mW to 2.7 W, is achieved. Design-III includes a CMOS based retina neuron circuit that employs a dynamic feedback technique and support to achieve the number of read-out spikes. At the end of the interface between wireless power devices and a CMOS retina neuron IC, 50 mV read-out spikes are achieved, with varying light intensity, from 0 mW/cm2 to 2 mW/cm2. The proposed design-II and design-III are implemented and fabricated using commercial CMOS 0.065 μm, Samsung process. The antenna and RF power harvesting IC could be placed on a contact lens platform while retina neuron IC can be implanted after ganglions cells inside the eye. The antenna and harvesting IC are physically connected to the retina circuit in the form of light. This conceptual investigation could support medical professionals in achieving an interfacing approach to restore the image visualization.

A Smart Bi-Directional Telemetry Unit For Retinal Prosthetic Device

A Closed Loop Transcutaneous Power Transfer System For Implantable Devices With Enhanced Stability

Design and Analysis of an Adaptive Transcutaneous Power Telemetry for Biomedical Implants

A Novel Design of Transcutaneous Power and Data Bidirectional Transfer System for Biomedical Implants

A Wireless Power and Bidirectional Data Telemetry Prototype Using a Single Inductive Link for Biomedical Implants.

A 27-Mbps, 0.08-mm3 CMOS Transceiver with Simultaneous Near-field Power Transmission and Data Telemetry for Implantable Systems

A 70%-power transmission efficiency, 3.39 Mbps power and data telemetry over a single 13.56 MHz inductive link for biomedical implants

High Efficiency Wireless Power Transmission with Digitally Configurable Stimulation Voltage for Retinal Prosthesis

A Conceptual Investigation at the Interface between Wireless Power Devices and CMOS Neuron IC for Retinal Image Acquisition

A Current-Switching Communication Technique for Miniaturized Medical Implants

An integrated low-power Binary-PAM based wireless telemetry circuit for implantable cardiac pacemakers

Low-Power Wireless Data Transfer System for Stimulation in an Intracortical Visual Prosthesis

An Ultra-Wideband-Inspired System-on-Chip for an Optical Bidirectional Transcutaneous Biotelemetry

A low power MICS band phase-locked loop for high resolution retinal prosthesis

Omnidirectional Wireless Power Transfer for Millimetric Magnetoelectric Biomedical Implants

A fully intraocular high-density self-calibrating epiretinal prosthesis

Implantable Wireless Power Receiver with Self-Displayed Power Meter

Challenges in System and Circuit Design for High Density Retinal Prosthesis

Design and Analysis of a Transcutaneous Telemetry Device for Brain Stimulator

An Inductive Wireless Telemetry Circuit with Ook Modulation for Implantable Cardiac Pacemakers

Adaptive Power Regulation and Data Delivery for Multi-Module Implants.