Abstract:The gas diffusion layer is an anisotropic porous medium, which provides pathways for the reactant gases and produced water, conducts the electrical current, removes the generated heat, and provides mechanical support. However, the gas diffusion layer is mostly considered as isotropic in numerical simulations. In the present study, a three‐dimensional, two‐phase flow, and non‐isothermal agglomerate model with consideration of anisotropic permeability, mass diffusivity, thermal conductivity, and electrical conductivity was developed and employed to investigate effects of anisotropic properties on the transport phenomena in a proton exchange membrane fuel cell. The temperature of the anisotropic case is less than that of the isotropic case, and the temperature difference increases with increasing current density. Furthermore, the distributions of the oxygen mass fraction, liquid water saturation, water content, and local current density for both cases are also compared and discussed in detail. The cell performance is over‐predicted by the isotropic model, and the current density of the isotropic case is greater than that of the anisotropic case by approximately 10% at an operating cell voltage of 0.3 V. Both the local transport characteristics and overall cell performance are different for the isotropic and anisotropic cases. Accordingly, it is concluded that the anisotropic properties of the gas diffusion layer must be taken into account in the mathematical model. Copyright © 2017 John Wiley & Sons, Ltd. A three‐dimensional, two‐phase flow, and non‐isothermal agglomerate model was developed and applied to investigate the effects of anisotropic properties of the gas diffusion layer on the transport phenomena and cell performance. The comparison results showed that the local transport characteristics predicted by the two models are different and the overall cell performance predicted by anisotropic model is lower than that of isotropic model.

A Simplified Method for Solving Anisotropic Transport Phenomena in PEM Fuel Cells

A three-dimensional PEM fuel cell model with consistent treatment of water transport in MEA

A Two-Dimensional Analysis of Mass Transport in Proton Exchange Membrane Fuel Cells

A three-dimensional mixed-domain PEM fuel cell model with fully-coupled transport phenomena

Influence of Heat Transfer on Gas and Water Transport in Fuel Cells

A two-phase non-isothermal mixed-domain PEM fuel cell model and its application to two-dimensional simulations

Simulation of PEM Fuel Cells Using the Mixed-domain Model

Numerical studies of liquid water behaviors in PEM fuel cell cathode considering transport across different porous layers

Numerical Modeling of Liquid Water Transport Inside and Across Membrane in PEM Fuel Cells

Numerical Studies of Interfacial Phenomena in Liquid Water Transport in Polymer Electrolyte Membrane Fuel Cells Using the Lattice Boltzmann Method

A single-phase, non-isothermal model for PEM fuel cells

Multi-dimensional Liquid Water Transport in the Cathode of a PEM Fuel Cell with Consideration of the Micro-Porous Layer (MPL)

Numerical Investigation of Transient Responses of a PEM Fuel Cell Using a Two-Phase Non-Isothermal Mixed-Domain Model

Electron Transport in PEFCs

Electron Transport in Gas Diffusion Layer of Polymer Electrolyte Fuel Cells

Numerical Modeling and Simulation of Pem Fuel Cells: Progress and Perspective

Large-scale Simulation of Polymer Electrolyte Fuel Cells by Parallel Computing

Multidimensional Modelling Of Polymer Electrolyte Fuel Cells Under A Current Density Boundary Condition

Analytical Calculation and Evaluation of Water Transport Through a Proton Exchange Membrane Fuel Cell Based on a One-Dimensional Model

A 3D, Multiphase, Multicomponent Model of the Cathode and Anode of a PEM Fuel Cell

Influence of anisotropic gas diffusion layers on transport phenomena in a proton exchange membrane fuel cell