Abstract:P-doped TiO2 nanoparticles were synthesized by the sol-gel method with various H3PO4 amounts. The samples were calcinated at different temperature and charactered by XPS, ICP, XRD, SEM, Raman, FTIR, and UV-vis methods, so that the formation process of phosphate species could be inspected. The XRD results show that P species hinder the particle growth of anatase and increase the anatase-to-rutile phase transformation temperature to more than 900 degrees C, and a new titanyl phosphate, Ti5O4(PO4)(4), was observed in P-doped TiO2 when calcined at 1000 degrees C. The UV-vis results indicate that the P species is likely to have two different states, leading to the variety of visible-light photocatalytic activity and band gap energy of P-doped TiO2. One state is the "separated phase". In this state, the P/Ti ratio is very low so that the P species is surrounded by TiO2. The "separated phase" of P species introduces oxygen into TiO2 lattice and hence causes a red-shift of the adsorption band edge of anatase, leading to the increased visible-light photocatalytic activity of P-doped TiO2. The other state is the "congregated phase". It appears at the micro region where the ratio of P/Ti is high enough to make the TiO2 clusters isolated by P species. The "congregated phase" of P species acts as the interface phase between TiO2 clusters and strongly retards the crystal growth of anatase, resulting in the widened band gap of P-doped TiO2. Furthermore, a possible mechanism was also proposed to explain the formation of the two phases during the sol-gel process. The results indicate that in order to improve the visible-light photocatalytic activity of P-doped TiO2 the percentage of "separated phase" in P species needs to be enhanced.

Effect of chelation on PL properties of Er3+-doped TiO2 powders prepared by sol-gel method

Chemical Combustion Synthesis and Up-Conversion Properties of Er3+ Doped Yb3Al5O12 Powder

Study of Erbium (iii) Doped Titanium Dioxide Nanoparticles by Photoacoustic Spectroscopy

Effect of different doped elements on visible light absorption and ultraviolet light emission on Er 3:Y 3Al 5O 12

Effects of Phase Structure on Up-Conversion Photoluminescence and Dielectric Performance in Er3+ Doped (bi0. 5na0. 5)Tio3-Batio3 Lead-Free Ceramics

Effects of Yttrium Codoping on Photoluminescence of Erbium-Doped TiO2 Films

Enhancement of Luminescent Properties of Sol-Gel-Derived BaTiO3: Pr

Opposite Effect of Li+ Codoping on the Upconversion Emissions of Er3+-Doped Tio2 Powders

Opposite effect of Li + codoping on the upconversion emissions of Er 3+ -doped TiO 2 powders

Upconversion and downconversion luminescence properties of Er3+ doped NBT ceramics synthesized via hydrothermal method

Coherent effect of Er3+–Yb3+ co-doping on enhanced photoluminescence properties of Al2O3 powders by the sol–gel method

Upconversion Luminescence Tuning of Er3+ Doped Barium Titanate

Effect of the P/Ti Ratio on the Visible-Light Photocatalytic Activity of P-Doped Tio2

Effects of Nd-doping on crystal phase, structure and photocatalytic performance of TiO 2 powders prepared by sol-gel method

Photoluminescence Performance of Er/Yb Co-Doped NBT Ceramics Prepared Via Hydrothermal Method

A study on the local environment of lanthanide ion in nanocrystalline titania

Effect of Er 3+ concentration on the upconversion luminescence of GdOCl:Er 3+ powders with excitation of 514.5 nm

Photoelectrocatalytic Property and DFT Calculations of TiO2 with Broadened Infrared Light Absorption by Gd2O3:Er3+

Effect of Er2O3 addition and calcining temperature on CaTiO3 material prepared by solid reaction

Upconversion Photoluminescence of Er-doped Bi$_{4}$Ti$_{3}$O$_{12}$ Ceramics Enhanced by Vacancy Clusters Revealed by Positron Annihilation Spectroscopy

Effect of Er substituting sites on upconversion luminescence of Er 3+-doped BaTiO 3 films