Abstract:It was discussed that the research progress and technical achievements had been obtained in the field of residual stress measurement and control of high-grade and large-diameter welded pipe for oil and gas transportation in China. (1) The layout scheme of measuring points and the requirements of spaces between measuring points, hole depth, etc., for residual stress measurement of welded pipe using hole drilling strain-gage method were proposed. On which, the residual stress measurement technology for welded pipe was proposed. (2) The measurement results indicate that the characteristics and distribution of residual stress of SAWH pipes with different grades and sizes were quite different. In general, the residual stress of SAWH pipe was highest, followed by JCOE pipe and UOE pipe. After the ring splitting test, SAWH pipe section usually had relative displacement in circumferential, axial and radial directions, and the degree of deformation varies greatly; But SAWL pipe section usually only occurs circumferential opening, without axial and radial stagger, and the circumferential opening of JCOE pipe was usually larger than that of UOE pipe. (3) Based on the mechanical analysis of the complex deformation of SAWH pipe after the ring splitting test and the superposition principle of elastic mechanics, a prediction model of the residual stress of the high-grade and large-diameter welded pipe suitable for SAWH pipe was established, which overcame the deficiency of the existing prediction models of the residual stress of the welded pipe only considering the circumferential deformation. (4) The key forming parameters affecting the residual stress of SAWH pipe were analyzed and determined as the reduction and forming angle. Combined with the finite element simulation analysis, field adjustment and residual stress analysis, the forming technology and residual stress control technology of low residual stress SAWH pipe were developed.

Circular combination ultrasonic measurement method of the residual stresses in welded pipes

Evaluation of Pipe Axial Defeat Through the Use of Ultrasonic Guided Wave and Matching Pursuit

Ultrasonic Technique For Testing Cold Welding Of Butt-Fusion Joints In Polyethylene Pipe

Residual stress nondestructive testing for pipe component based on ultrasonic method

Electromagnetic Ultrasonic Measurement for Welding Residual Stress Detection - Comparison Between Experiment with Numerical Simulation

Nondestructive Measurement System for Welding Residual Stress by Ultrasonic Method

AL7N01 butt joint welding residual stress measurement by ultrasonic method

Research on Welding Residual Stress Measurement Using Electromagnetic Acoustic Transducer

Evaluation of Transverse Residual Stress in Twin Wire Welded Plates by Ultrasonic Method

Measurement of Welding Residual Stress by Ultrasonic Technology

Nondestructive measurement system for welding resdiual stress by ultrasonic method

Rapid and Nondestructive Measurement System for Welding Residual Stress by Ultrasonic Method

Ultrasonic Monitoring of Residual Stress Reduction Methods

Ultrasonic Stress Evaluation on Welded Plates with Lcr Wave

Measurement and Control of Residual Stress of High-Grade and Large-Diameter Welded Pipe for Oil and Gas Transportation

Experiment and Numerical Simulation for Laser Ultrasonic Measurement of Residual Stress

Welding residual stress analysis of the X80 pipeline: simulation and validation

Weld Quality Inspection of Small-Diameter Thin-Walled Pipes by a Laser Ultrasonic Method.

A Study on the Ultrasonic Regulation of the Welding Performance and Residual Stress of 316L Stainless Steel Pipes

Ultrasonic immersion testing of residual stress in plates using collinear Lamb wave mixing technique

Numerical investigation on residual stress distribution and evolution during multipass narrow gap welding of thick-walled stainless steel pipes