Potential-induced structural transitions of DL-homocysteine monolayers on Au(1 1 1) electrode surfaces

Jingdong Zhang,Anna Demetriou,Anne Christina Welinder,Tim Albrecht,Richard J. Nichols,Jens Ulstrup

DOI: https://doi.org/10.1016/j.chemphys.2005.04.019

IF: 2.552

2005-01-01

Chemical Physics

Abstract:Monolayers of homocysteine on Au(111)-surfaces have been investigated by voltammetry, in situ scanning tunnelling microscopy (STM) and subtractively normalised interfacial Fourier transform spectroscopy (SNIFTIRS). A pair of sharp voltammetric peaks build up in the potential range 0 to −0.1V (vs. SCE) in phosphate buffer pH 7.7. The peak half-widths are about 25mV at a scan rate of 10mVs−1. This is much smaller than for a one-electron Faradaic process (90.6mV) under similar conditions. The coverage of homocysteine is 6.1 (±0.2)×10−10 molcm−2, or 5.9×10−5 Ccm−2, from Au–S reductive desorption at −0.8V (SCE) in 0.1M NaOH, while the charge is only about 8×10−6 Ccm−2 (pH 7.7) for the 0 to −0.1V peak. This suggests a capacitive origin. The peak potential and shape depend on pH. At pH 7.7 both cathodic and anodic peak currents reach a maximum, but drop at both higher and lower pH. The midpoint potential shows biphasic behaviour, decreasing linearly with increasing pH until pH 10.4 towards a constant value at higher pH. The cathodic and anodic peak charges decay at pH both higher and lower than 7.7.