Abstract:This paper analytically investigates a fully developed forced convection in a channel partially filled with two porous layers symmetrically arranged at inner walls. The local thermal non-equilibrium (LTNE) model and Brinkman-extended Darcy model are employed as energy and momentum equations respectively in porous region. Three thermal boundary conditions (models A, B and C) and no-slip condition are adopted at porous-fluid interface. Explicit expressions of solid and fluid temperatures and Nusselt number are derived under each thermal boundary condition and variances between the three thermal boundary conditions in predicting thermal behaviors are discussed. It is shown that with present parameters, the temperature bifurcation phenomenon occurs in most cases under model B, while this phenomenon cannot be observed under models A and C. The LTNE model holds in almost any conditions under model B, but under models A and C the LTNE model holds with a low hollow ratio (S) and Biot number (Bi), a large effective thermal conductivity ratio (K) and Darcy number (Da). The increase of interfacial convective heat transfer coefficient (Hs) makes the Nusselt number (Nu) of model C more close to but not exceed the Nu of model A, while the Nu under model B is lower than which under models A and C. By using different thermal boundary conditions, the stress jump coefficient (β) effect on heat transfer can be ignored, and with a high Da, a low β and S the Nu number predicted by stress jump interface condition has slight difference from that by stress continuity interface condition.

Influence of Variable Property Effects on Heat Transfer in an Channel with Discrete Protruded Heat Sources

Variable Permeability Effects on Natural Convection in a Vertical Porous Layer with Uniform Heat Flux from the Side

Numerical Analysis of Mixed Convective Heat Transfer In a Square Channel with Uniform Wall Temperature.

Thermal Drag and Critical Heat Flux for Natural Convection of Air in Vertical Parallel Plates

Three-Dimensional Numerical Analysis of Mixed Convective Heat Transfer in a Horizontal Square Channel with Heated and Cooled Side Walls.

NUMERICAL INVESTIGATION ON THE EFFECTS OF VISCOUS DISSIPATION AND VARIABLE THERMO-PHYSICAL PROPERTIES ON FORCED CONVEC-TION HEAT TRANSFER IN POROUS MEDIA

Heat Transfer and Flow of a Slag-Type Non-Linear Fluid: Effects of Variable Thermal Conductivity.

Fluid Flow and Conjugate Heat Transfer in a Channel with Inflow from a Porous Wall

Influence of variable thermophysical properties and thermal radiation on convection heat transfer in transpiration cooling

Effect of thermal boundary conditions on forced convection under LTNE model with no-slip porous-fluid interface condition

Numerical simulation and optimization on convective heat transfer characteristic in rectangular macro channel by high heat flux

EXPERIMENTAL INVESTIGATION OF HEAT TRANSFER DEPENDENCY ON CONJUGATE AND CONVECTIVE THERMAL BOUNDARY CONDITIONS IN PIN FIN CHANNEL

Numerical investigation of forced convection heat transfer in porous media using a thermal non-equilibrium model

Large eddy simulation of turbulent heat transfer in a non-isothermal channel: Effects of temperature-dependent viscosity and thermal conductivity

Numerical Analysis of Flow Boiling Characteristics of a Single Channel Heat Sink Subjected to Multiple Heat Sources

Analysis of transient laminar forced convective heat transfer in parallel-plate channels with time-varying thermal boundary conditions of the inlet and wall

Influence of Variable Thermophysicai Properties and Thermal Radiation on Convection Heat Transfer in Transpiration Cooling

Effect Of Variable Thermophysical Properties On Laminar Free-Convection Of Polyatomic-Gas

Experimental and numerical investigation of convection heat transfer in transpiration cooling

Forced Convective Heat-Transfer in A Vertical Annulus Filled with Porous-Media

Friction and heat transfer in forced air convection with variable physical properties