Abstract:Pt or Pt-alloys are used in proton exchange membrane fuel cell (PEMFC) as oxygen reduction reaction (ORR) catalyst. It is well known that anions such as sulfate, when adsorbed on catalyst surface, can significantly impede the ORR. The impact of (bi)sulfate adsorption on ORR kinetics has been reported on both well characterized Pt single crystal surfaces, as well as on supported Pt/C catalyst in aqueous electrochemical cell. Furthermore, the reversible performance loss induced by membrane chemical degradation observed in PEM fuel cells is ascribed to adsorption of sulfate on Pt or Pt-alloy catalyst. The performance loss will become more significant at reduced Pt loading, which is desired to enable PEMFC-powered electric vehicles to be cost competitive. Therefore, a thorough understanding of sulfate adsorption on ORR is much needed. The interaction of (bi)sulfate anions with Pt electrocatalyst surface in electrolyte solution have been well documented. It is generally agreed that (bi)sulfate adsorbs on Pt(111) via the 3-fold oxygen sites. Auger electron spectroscopy (AES), coulometry, and radiotracer method have been employed by Wieckowski and coworkers to quantify the amount of adsorbed sulfate on Pt (111) electrode exposed to dilute sulfuric acid solution. It was observed that the sulfate surface coverage depends on potential and sulfuric acid concentration. Although the impact of sulfate adsorption on ORR has been extensively reported, majority of the previous work have been qualitative. Quantitative studies were very rare in the literature. Therefore, in the present work we attempt to establish the correlation between the ORR activity and sulfate concentration in the solution through the surface coverage of sulfate anion on the catalyst. The mass activity (in unit of A/mgPt) of 30%wt. PtCo/HSC catalyst was measured in a three-electrode electrochemical cell using RDE (Pine Instrument Co., USA). A silver/silver chloride electrode was employed as reference electrode which was separated from the working electrode compartment by a salt bridge. However, the potential reported in this work refers to that of the reversible hydrogen electrode (RHE). The ORR activity of the Pt-alloy catalyst was measured in 0.1 M HClO4 free of H2SO4 and in 0.1 M HClO4 solutions doped with various concentration of H2SO4 ranging from 0.001 to 0.05 mM. The anodic sweep was recorded in O2-saturated electrolyte at a rotation speed of 1600rpm and a sweep rate of 5 mV/s. All measurements were conducted at room temperature. The mass activity measured at 0.9V (vs. RHE) is shown in Figure 1 (diamonds and solid black line in the figure). The ORR activity drops from 0.39 A/mgPt to 0.33 A/mgPt in the presence of 0.001 mM H2SO4, and further decreases with the increase of sulfate concentration. The correlation between sulfate coverage on the catalyst surface and sulfate concentration in the electrolyte solution was obtained from ref. 4, assuming the adsorption of sulfate on PtCo nanoparticles follows that of the Pt(111) single crystal (Fig. 2). (Bi)sulfate surface coverage increases with bulk sulfuric acid concentration following a semi-logarithmic isotherm. Finally, a simple kinetic model was used to calculate the impact of sulfate surface coverage on ORR activity. These results will be presented.

Influence of phosphate anion adsorption on the kinetics of oxygen electroreduction on low index Pt(hkl) single crystals.

Mitigating Phosphate Anion Poisoning of Cathodic Pt/C Catalysts in Phosphoric Acid Fuel Cells

Impact of Sulfate Adsorption on the Kinetics of Oxygen Reduction Reaction

Impacts of anions on the oxygen reduction reaction kinetics on platinum and palladium surfaces in alkaline solutions

Investigation of Phosphoric Acid Influence on the Oxygen Reduction Reaction on Carbon-Supported Platinum Electrocatalyst via Rotating Disk Electrodes

Ph Effect on Oxygen Reduction Reaction at Pt(1 1 1) Electrode

Ph Effect On Oxygen Reduction Reaction At Pt(111) Electrode

Deciphering the linear relationship in the activity of the oxygen reduction reaction on Pt electrodes: A decisive role of adsorbates

Structurally Disordered Phosphorus-Doped Pt as a Highly Active Electrocatalyst for an Oxygen Reduction Reaction

Effect of Hydrophobic Cations on the Inhibitors for the Oxygen Reduction Reaction on Anions and Ionomers Adsorbed on Single-Crystal Pt Electrodes

Phosphorus-Enhanced Oxygen Reduction Activity and Stability of Commercial Pt/C

Kinetics Study on O2 Adsorption and OHad Desorption at Pt(111), Its Implication to Oxygen Reduction Reaction Kinetics

Theoretical Study on the Regulation of Oxygen Reduction Mechanism by Modulating the Spatial Structure of Active Sites on Platinum

A kinetic descriptor for the electrolyte effect on the oxygen reduction kinetics on Pt(111)

Oxygen Reduction Reaction on PtCo Nanocatalyst: (bi)sulfate Anion Poisoning

O 2 surface concentration change and its implication on oxygen reduction mechanism and kinetics at platinum in acidic media

Fighting Poison with Poison: Enhancing the Performance of Oxygen Reduction Reaction on Pt(111) Via Trace Halide Ion Addition

The Effect of Anions and pH on the Activity and Selectivity of an Annealed Polycrystalline Au Film Electrode in the Oxygen Reduction Reaction‐Revisited

Influence of the Pt/ionomer/water interface on the oxygen reduction reaction: insights into the micro-three-phase interface

(Invited) How Oxygen-Containing Intermediates and Surface Charge Regulate Oxygen Reduction Reaction of Platinum Electrocatalysts

Density Functional Theory Study of Oxygen Reduction Reaction on Pt/Pd3al(111) Alloy Electrocatalyst