Abstract:Direct measurement and control of the dynamic wetting properties of a lipid-coated water-air interface over a wide range of surface tension variations have many important applications. However, the wetting dynamics of the interface near its partial-to-complete wetting transition has not been fully understood. Here, we report a systematic study of the wetting dynamics of a lipid-coated water-air interface around a thin glass fiber of diameter 1-5 μm and length 100-300 μm. The glass fiber is glued onto the front end of a rectangular cantilever to form a "long-needle" atomic-force-microscope probe. Three surface modifications are applied to the glass fiber to change its wetting properties from hydrophilic to hydrophobic. A monolayer of phospholipid dipalmitoylphosphatidylcholine (DPPC) is deposited on the water-air interface in a homemade Langmuir-Blodgett trough, and the surface tension γL of the DPPC-coated water-air interface is varied in the range of 2.5 ≲ γL ≲ 72 mN/m. From the measured hysteresis loop of the capillary force for the three coated fiber surfaces with varying γL, we observe a sharp transition from partial to complete wetting when γL is reduced to a critical value (γL)c. The obtained values of (γL)c are 27 ± 1 mN/m for a DPPC-coated fiber surface and 23 ± 1 mN/m for an trichloro(1H,1H,2H,2H-perfluorooctyl) silane (FTS)-coated surface. Below (γL)c, the contact angle θ0 of the liquid interface is found to be zero for both hydrophobic fiber surfaces and the corresponding spreading parameter S becomes positive. For the FTS-coated fiber surface, the height of capillary rise exhibits a jump when γL is reduced to (γL)c, which indicates that a rapidly advancing liquid film is formed on the fiber surface when the partial-to-complete wetting transition takes place. Our experiment thus establishes a quantitative method by which many other liquid interfaces coated with polymers, surfactants, and biomolecules (such as proteins and lipids) may be characterized dynamically.

Surface Wettability of Compressed Polyelectrolyte Multilayers

Ultrahydrophobicity Of Polydimethylsiloxanes-Based Multilayered Thin Films

Influence of Drying Time of Polyelectrolyte Multilayers on the Compression-Induced Pattern Formation

Controlling Pore Size and Wettability of A Unique Microheterogeneous Copolymer Film with Porous Structure

Surfactant Co-Assembly and Ion Exchange to Modulate Polyelectrolyte Multilayer Wettability

Polyelectrolyte Multilayers under Compression: Concurrent Osmotic Stress and Colloidal Probe Atomic Force Microscopy.

Compression-Inhibited Pore Formation of Polyelectrolyte Multilayers Containing Weak Polyanions: A Scanning Force Microscopy Study

Mechanism of Surface Molecular Imprinting in Polyelectrolyte Multilayers.

Comparative Molecular Dynamics Simulation of Wetting on Liquid-like Surfaces

Loading and release behaviors of compressed polyelectrolyte multilayers for small dye molecules.

Wetting Dynamics of a Lipid Monolayer

Molecular Dynamics Simulations Of Wetting Behavior Of Water Droplets On Polytetrafluorethylene Surfaces

Hydrophilicity–hydrophobicity Adjustable Polymer-Modified Surfaces from One-Step Dip-Coating Method

Dual‐responsive Copolymer Poly(2,2,3,4,4,4‐hexafluorobutyl Methacrylate)‐block‐poly[2‐(dimethylamino)ethyl Methacrylate] Synthesized Via Photoatrp for Surface with Tunable Wettability

Patterned Polymer Surfaces with Wetting Contrast Prepared by Polydopamine Modification

Functional Polyelectrolyte Multilayer Assemblies for Surfaces with Controlled Wetting Behavior

Wetting Behavior of Polyelectrolyte Complex Coacervates on Solid Surfaces

Mechanics of micropattern-guided formation of elastic surface instabilities on the polydimethylsiloxane bilayer

Tunable Wettability and Rewritable Wettability Gradient from Superhydrophilicity to Superhydrophobicity

The Effect of Surface Structure and Arrangement on Wettability of Substrate Surface

Superhydrophobic Surfaces Fabricated by Spray-Coating Micelle Solutions of Comb Copolymers