Abstract:Objectives: This study was designed to examine the impact of sinus floor elevation on stress distribution around implants.Methods: CT scanning data were collected from a female volunteer,a 3-dimensional finite element model of maxillary bone with maxillary sinus and without first molar was set up using Mimics 11.0 software.Maxillary sinus floor with limited bone height was computer-simulated.A total of 4 models of the posterior maxilla with implant were computer-simulated by varying the thickness of the grafted bones(0,2,4,and 6 mm),0 mm artificial bone model was as control.Loading of the implants,in 3D,with forces of 100 N in an axial,buccal 30°,and lingual 30° directions respectively.A finite element analysis was performed to examine the stress distribution in the bone surrounding implants.Results: Under the same loading,the maximum von Mises stresses of cortical bone was the largest,the maximum von Mises stresses of concelous bone was similar to that of artificial bone.To large extent,the maximum von Mises stresses around implants after the first drop and then rise with the increase of grafted bone heights.4 mm grafted bone model showed the smallest stress.The maximum von Mises stresses under axial loading were markedly higher than those under buccal or lingual loadings.Conclusions: From a biomechanical viewpoint,maxillary sinus floor elevation with bone graft can decrease the stress distributions around the implants in the setting of posterior maxillary bone loss,4 mm grafted bone model showed the smallest stress,axial loading leads to lower strains as compared with oblique loading.In clinical implant design,the oblique loading should be avoided.

Maxillary Sinus Floor Elevation and Implant Biomechanics: A Finite Element Analysis