Abstract:The stereo-vision methods have been developed and used for measuring the wing deformation while the aircraft is in flight. However, it is difficult to achieve accurate measurement in flight test since inevitable camera movements often occur due to elasticity in the camera support and the surrounding structure, especially during heavy turbulence and large maneuver flight. Any slight camera movements within a stereo-vision system can directly influence the calibrated extrinsic parameters, then decrease 3D reconstruction accuracy, and even cause the measurement to fail. This study proposes a method to correct the effect of the camera movements to enable accurate wing deformation measurement using a stereo-vision system. A reference coordinate system is established based on the control points to unify the changing camera coordinate system. A dynamic extrinsic parameters calibration algorithm is developed to estimate the instantaneous position and orientation of the stereo cameras. To verify the presented method, an experiment in which the stereo cameras occurring relative movement was performed. The results show that the proposed method has effectively corrected the effects of camera movements. Furthermore, the proposed method was applied to the practical wing deformation measurement of a UAV in fieldwork. The maximum error of length and displacement is less than 0.8 mm when the stereo cameras remained unchanged. The actual accuracy of the overall measurement system is about 0.01% of the observed area (e.g. 0.8 mm in 6 m scale) under the conditions of flat viewing angle and outdoor scenes. While camera movements occur during the test, the corrected RMS error of displacement is reduced to about 1.5 mm and has decreased by 50% compared with that before correction. The enhanced precision and robustness of wing deformation measurement are well realized by the proposed method of correcting camera movements.

A Method of Measuring Poses of the Aircraft Model Based Computer Vision

Enhanced Pose Adjustment System for Wing-Box Assembly in Large Aircraft Manufacturing.

The Free Surface Ultrasonic Measuring and Checking Robot Kinematics Analysis

Stereo Vision for Spin Tests in the Vertical Wind Tunnel

Posture evaluation method for aircraft component based on hole feature

Wind Measurement by Computer Vision on Unmanned Sailboat

Saddle Point Programming Based Level-Posture Evaluation Method for Aircraft Wings

Pose measurement method and experiments for high-speed rolling targets in a wind tunnel

A Novel Vision-Based Pose Measurement Method Considering the Refraction of Light

Pose Measurement of Small-Size Aircraft Based on Machine Vision

Position and pose measurement technology of space combination ground experiment based on machine vision

A measurement method of motion parameters in aircraft ground tests using computer vision

Large-Scale Aircraft Pose Estimation System Based on Depth Cameras

An Online and Vision-Based Method for Fixtured Pose Measurement of Nondatum Complex Component

Wing Deformation-Aware Vision-Based Airplane Attitude Measurement

Optical and Dynamic Measuring System for Movement Data of Aircraft Structural Parts

Study and application of monitoring plane displacement of a similarity model based on time-series images

Wing deformation measurement using the stereo-vision methods in the presence of camera movements

Research on the Pose Error Compensation Technology for the Mass and Centroid Measurement of Large-Sized Aircraft Based on Kinematics

Optical Measurement of Aircraft Attitude Parameters and Accuracy Monte Carlo Simulation

Measurement Approach for the Pose of Flanges in Cabin Assemblies through Distributed Vision