Abstract:PurposeOxides are ubiquitous in nature and play an important role in scavenging metal ions from soils and sediments. At the common pH range of the natural environment the well-studied Fe and Al oxides mostly carry a positive charge and adsorbed amounts of heavy metals, and their desorption percentages decrease with increasing ionic strength. The less well studied but also important Mn oxides possess negative charges in the natural environment and this will lead to a different behavior. Therefore, it is useful to further investigate how the electrolyte concentration and type affect the metal ion adsorption/desorption by Mn oxides.Materials and methodsThe phyllomanganate birnessite was synthesized with hydrochloric acid and potassium permanganate, and characterized by X-ray diffraction and transmission electron microscopy. The point of zero charge and specific surface area (SSA) were determined by, respectively, the rapid potentiometric titration method and BET-N2 method. The adsorption was measured after shaking the samples in contact with Cu(NO3)2 solution for 2 h and further equilibration for 22 h at pH 4.5 and 25 ± 1°C. The 1-1 electrolyte concentrations were adjusted to 0, 0.001, 0.01, 0.1, 0.5, and 1 mol L−1 KNO3 or KCl.Results and discussionThe PZC and SSA of synthetic birnessite were 2.5 and 75 m2 g−1, respectively. The birnessite consisted of small needle-like particles. A maximum amount of Cu2+ adsorbed on birnessite of 208 ± 8 mmol kg−1 and 2.77 ± 0.11 µmol m−2 by using the BET area is obtained. The adsorption amount decreased gradually with increasing ionic strength. This is primarily due to screening of the electrostatic attraction. For the same reason the percentage of desorption of Cu2+ previously adsorbed on birnessite increased with increasing electrolyte concentration. Furthermore, the decrease of Cu2+ adsorption with increasing ionic strength was higher in KCl solution than in KNO3 solution. This difference is most likely related to Cu2+–Cl− complexation.ConclusionsThe type and concentration of 1-1 electrolyte affect the Cu2+ adsorption/desorption characteristics on Mn oxide. The amounts of Cu2+ adsorbed on birnessite reduced, and the desorption percentage increased with increasing 1-1 electrolyte concentration. These results are opposite to that of metal ion binding to positive Fe and Al oxides. The principal differences can be explained on the basis of generic electrostatic effects.

Cation Adsorption of NpO2+, UO22+, Zn2+, Sr2+, Yb3+, and Am3+ Onto Oxides of Al, Si, and Fe from Aqueous Solution: Ionic Strength Effect

Relative Strength of Polycation Adsorption on Oxide Surfaces

Influence of ionic environment on the process of adsorption of heavy metal ions on magnetic iron oxides

Influence of ionic strength, anions, cations, and natural organic matter on the adsorption of pharmaceuticals to silica

Effect of Fulvic Acids on Sorption of U(VI), Zn, Yb, I and Se(IV) Onto Oxides of Aluminum, Iron and Silicon

Cation adsorption at permanently (montmorillonite) and variably (quartz) charged mineral surfaces: Mechanisms and forces from subatomic scale

Non-Competitive And Competitive Adsorption Of Pb2+, Cd2+ And Zn2+ Ions Onto Sds In Process Of Micellar-Enhanced Ultrafiltration

Adsorption of Metal Ions at Kaolinite Surfaces: Ion-specific Effects, and Impacts of Charge Source and Hydroxide Formation

Modeling The Adsorption Of Cd (Ii), Cu (Ii), Ni (Ii), Pb (Ii) And Zn (Ii) Onto Montmorillonite

Effects of Electronegativity and Hydration Energy on the Selective Adsorption of Heavy Metal Ions by Synthetic NaX Zeolite

Effects of Anions on the Capacity and Affinity of Copper Adsorption in Two Variable Charge Soils

Adsorption Behavior of Co2+, Ni2+, Sr2+, Cs+, and I− by Corrosion Products α-FeOOH from Typical Metal Tanks

Effects of Solution Chemistry Conditions and Adsorbent Surface Properties on Adsorption of Ni(Ii) on Laiyang Bentonite

Effect of 1-1 electrolyte concentration on the adsorption/desorption of copper ion on synthetic birnessite

Kinetics and Mechanism of Sr(II) Adsorption by Al-Fe 2 O 3 : Evidence from XPS Analysis

Competitive Adsorption of Metal Ions at Smectite/Water Interfaces: Mechanistic Aspects, and Impacts of Co-Ions, Charge Densities, and Charge Locations

Lead (II) ions enable the ion-specific effects of monovalent anions on the molecular structure and interactions at silica/aqueous interfaces

The Impacts of Common Ions on the Adsorption of Heavy Metal

Effect of Concentration and Addition of Ions on the Adsorption of Sodium Dodecyl Sulfate on Stainless Steel Surface in Aqueous Solutions

Sulfate enhances the adsorption and retention of Cu(II) and Zn(II) to dispersed and aggregated iron oxyhydroxide nanoparticles

Impact of natural organic matter and divalent cations on the stability of aqueous nanoparticles