Solvent Extraction of Copper from Ammoniacal Chloride Solutions by Sterically Hindered Β-Diketone Extractants

Weng Fu,Qiyuan Chen,Huiping Hu,Chunlin Niu,Qinqin Zhu

DOI: https://doi.org/10.1016/j.seppur.2011.04.005

IF: 8.6

2011-01-01

Separation and Purification Technology

Abstract:Separation and recovery of copper from synthetic ammoniacal chloride solutions were carried out systematically by solvent extraction using 1-phenyl-3-heptyl-1,3-propanedione (I), 1-phenyl-4-ethyl-1,3-octanedione (II) and 1-(4′-dodecyl) phenyl-3-tert-butyl-1,3-propanedione (III) in kerosene. The selectivity of copper over zinc and nickel and the stripping efficiency of copper were greatly enhanced as the steric hindrance of β-diketones increased in the order I<II<III; the co-extraction of ammonia in copper loaded organic phases and the extractability of copper declined with the increase of steric effects. The results indicated that the most highly sterically hindered β-diketone extractant III demonstrated the best selectivity for the separation of copper from nickel and zinc, co-extracted the least amount of ammonia and exhibited the highest stripping efficiency. The copper ion was extracted with β-diketone extractants I, II and III via a cation exchange mechanism, and the slope analysis suggested that the copper chelates a copper: reagent mole ratio of 1:2. The quantitative extraction of copper was obtained in two counter current stages at an equilibrium pH of 10.0 and an A:O phase ratio of 2:1 with 1.0M β-diketone extractants I, II and III. The copper stripping efficiencies from the three loaded β-diketone organic phases with 60kg/m3 H2SO4 as strip solution in two stages at an A:O of 1:2 reached over 99.97%. The FT-IR analysis suggested that the decrease in the stabilities of copper chelates arose from the increase in the steric hindrance of β-diketones in the order of I<II<III, leading the decrease in copper extractabilities and the increase in the stripping efficiencies in the same order I<II<III.