Abstract:Enhancement of thermal stability in Al-Ni alloys through microalloying with slow-diffusing elements, specifically Zr, has been previously reported which is attributed to Zr segregation at the Al/Al 3 Ni interface. In this study, we explore the influence of microalloying Al-Ni alloys with Zr, Ti, V, and Fe on microstructural evolution, hardness, and electrical and thermal conductivity across a range of heat-treatment temperatures from 300 to 450 °C. The distribution of microalloying elements and precipitates after heat treatment is characterized using atom probe tomography (APT). Our investigation confirms Zr segregation to the Al/Al 3 Ni interface, while similar interfacial segregation is absent with the addition of Ti, V, and Fe. Additionally, our analysis of the Al 3 Ni microfiber morphology reveals that their coarsening and spheroidization rates are similar with and without interfacial segregation; thus, retaining the fiber reinforcement through interfacial segregation of slow diffusing elements may not be an effective strategy. Precipitation of L1 2 nanoparticles was found to be the dominant mechanism affecting enhanced hardness and electrical conductivity in Al-Ni-Zr alloys, attributed to precipitation strengthening and solute depletion, respectively. Similar precipitation was not observed for additions of Ti, V, and Fe following heat treatment. We provide a thermodynamic explanation for this limitation. The findings of this study suggest that an effective approach for designing Al-Ni alloys should involve prioritizing microalloying elements to maximize L1 2 precipitation and minimize solute content in the FCC-Al matrix post heat treatment, rather than focusing on Al/Al 3 Ni interfacial segregation.

Martensitic Transformation and Its Effects on Permeability-Frequency Spectra of FeNiZrBCu Alloys

Effects of Ambient Gasses on the Magnetic Properties of Fe84.8Zr3.4Nb3.4B7.4Cu1 Nanocrystalline Alloy

Effect of Annealing on the Microstructure and Magnetic Properties of Fe-based Nanocomposite Materials

Effect of Annealing Temperature on Permeability and Giant Magneto-Impedance of Fe-based Amorphous Ribbon

High-temperature Magnetic Properties of Fe-based Nanocrystalline Alloy

Effects of Microstructure on the Temperature Dependence of Relative Initial Permeability of NiCuZn Ferrites

The effects of nitridation on the permeability-frequency spectra in nanocrystalline Fe<sub>88</sub>Zr<sub>7</sub>B<sub>4</sub>Cu alloys

The effect of Ni addition on microstructure and soft magnetic properties of FeCoZrBCu nanocrystalline alloys

Permeability–frequency spectra of Nanoperm alloys under different heat treatment conditions

Dependence of the Permeability-Frequency Spectra of Fe88Zr7B4Cu Alloys on Dc Magnetic Fields

Effect of Cooling Rate on Dynamic Magnetization of Fe86Zr7B6Cu Nanocrystalline Alloy

Effect of Ni Substitution for Si Element on Thermal and Soft Magnetic Properties of Fe73.5NixSi15.5-xB7Nb3Cu1 Nanocrystalline Alloys

Effects of Nitrogen Addition on the Microstructures and Soft Magnetic Properties of Nanocrystalline Fe86zr7b6cu1 Ribbons

Effect of the structure and volume fraction of nanophase on the mechanical properties of (FeNi)86B14 amorphous nanocrystalline alloys

Permeability‐frequency Spectra of Nanoperm Alloys at Different Temperatures

Unusual alloying effects of Co and Ni on structure and magnetic properties of Fe-Si-B-Cu nanocrystalline alloys with pre-existing α-Fe nanocrystals

Crystallization and Soft Magnetic Behavior of Fe85.6−Mo Zr3.3Nb3.3B6.8Cu1 Alloys

Effect of microalloying additions on microstructural evolution and thermal stability in cast Al-Ni alloys

Influence of Ni Substitution for B on Crystallization Behavior, Microstructure and Magnetic Properties of FeBCu Alloys

Effect of Annealing Time on the Magnetic Properties of FeNiCuNbSiB Dual-Phase Alloys

Effect of Ni addition on the microstructure, conductivities and mechanical properties of as-cast Al-Fe alloys