Abstract:Delafossite CuAlO2 has great potential in optoelectronics applications. The intrinsic point defects play the decisive roles in the optoelectronic properties and application of CuAlO2. However, there are still disputes about their relevant underlying physical mechanisms at the atomic scale. Here, the formation of intrinsic point defects of CuAlO2 and their effects on optical absorption spectra and electronic structure have been systematically investigated using first‐principles calculations. In oxygen‐rich and oxygen‐poor chemical environments, acceptor‐type defects such as Cu vacancy and Cu substitution on the Al site can spontaneously form and produce p‐type conductivity at room temperature. This is the important physical basis for CuAlO2 to be widely used as transparent conductive oxide films. The shallow acceptor‐type levels produced by Cu substitution on Al site and O vacancy, and the shallow donor‐type levels produced by interstitial Cu, are favorable for the separation of photo‐generated electron‐hole pairs, which can be suitable for applications in photocatalysis and photovoltaics. The Cu or Al vacancy can produce delocalized energy band at the top of valence band and pinning Fermi level at the same time, which may make CuAlO2 a degenerate semiconductor and produce local surface plasmon resonance effect. Al substitution on Cu site and interstitial Al or O form complex deep defect energy bands in the forbidden band and produce significant multiband optical absorption in the visible‐NIR region. They are expected to become alternative materials for photoluminescence and photoelectric detection. This work demonstrates the importance of intrinsic defect engineering for optimizing optoelectronic properties and thus promoting the discovery of novel optoelectronic materials. This article is protected by copyright. All rights reserved

Synthesis and Performance of Baal2o4 with A Wide Spectral Range of Optical Absorption

Optical Properties of Al 2 O 3 Thin Film Fabricated by Atomic Layer Deposition

The influence of oxygen vacancy on the electronic and optical properties of ABO 3-δ (A = La, Sr, B = Fe, Co) perovskites.

Hybrid Density Functional Studies for the Effect of Oxygen Vacancy on the Visible Light Photocatalytic Activity in M (m=li, Na, K, Rb, Cs)-doped Α-Bi2o3

Design and synthesis of a nonlinear optical material BaAl 4 S 7 with a wide band gap inspired from SrB 4 O 7

First-Principles and Experimental Study of Trace Impurities and Near-Infrared Emission in Alkaline Earth Hexaaluminates

Optical investigation and computational modelling of BaTiO3 for optoelectronic devices applications

Manipulation of Optical Transmittance by Ordered-Oxygen-Vacancy in Epitaxial LaBaCo2O5.5+δ Thin Films

Impedance Spectroscopy and Dielectric Properties of BaAl(2−2)(Zn0.5Ti0.5)2O4 Ceramics

New insights into intrinsic point defects of Delafossite CuAlO2 as optoelectronic materials

Synthesis of cubic and tetragonal Ba2SmTaO6 and their optical properties after Sr doping

Na2BaB12O18F4: A Mixed Alkali/Alkaline-Earth Metal Fluorooxoborate with Two Unprecedented Interpenetrating Three-Dimensional B-O/F Anionic Networks and a Short Ultraviolet Cutoff Edge.

Realization of Electron Antidoping by Modulating the Breathing Distortion in BaBiO 3

Optimization of BaMgAl 10 O 17 :Eu 2+ Phosphors by the Substitution of Si-N Bonds for Al-O Bonds

Preparation and Dielectric Characterization of BaLaAlO 4 Ceramics

Structure evolution and energy band modulation in Ba-doped BiFeO3 thin films

Theoretical study on composition‐dependent properties of ZnO· n Al 2 O 3 spinels. Part I: Optical and dielectric

Prediction of ultraviolet optical materials in the K2O-B2O3 system

Microwave dielectric properties and thermally stimulated depolarization of Al‐doped Ba4(Sm,Nd)9.33Ti18O54 ceramics

Oxygen Vacancy-Related Dielectric Relaxation and Electrical Conductivity in La-doped Ba(Zr 0.9 Ti 0.1 )O 3 Ceramics

Oxygen Deficiency Induced Strong Electron Localization In Lanthanum Doped Transparent Perovskite Oxide Basno3