Determining the Geometry and the Cosmological Parameters of the Universe Through Sunyaev-Zeldovich Effect Cluster Counts

ZH Fan,TH Chiueh
DOI: https://doi.org/10.1086/319780
2001-01-01
Abstract:We study Sunyaev-Zeldovich effect (SZE) cluster counts in different cosmologies. We find that even without full knowledge of the redshift distribution of SZE clusters, one can still readily distinguish a flat universe with a cosmological constant from an open universe. We divide clusters into a low-redshift group (with redshift z less than or equal to 0.5) and a high-redshift group (with z greater than or equal to 1), and compute the ratio of r = N(z less than or equal to 0.5)/N(z greater than or equal to 1), where N(z less than or equal to 0.5) is the number of flux-limited (S-v(lim)) SZE clusters with z less than or equal to 0.5, and N(z greater than or equal to 1) is the number of flux-limited SZE clusters with z greater than or equal to 1. With about the same total number of SZE clusters N(z greater than or equal to 0), the r values for a flat universe with a nonzero cosmological constant and for an open universe occupy different regions in the S-v(slim)-r plot for the most likely cosmological parameters 0.25 less than or equal to Ohm (0) less than or equal to 0.35 and 0.2 less than or equal to Gamma less than or equal to 0.03, where Ohm (0) is the matter density parameter of the universe and Gamma is the shape parameter of the power spectrum of linear density fluctuations. Thus, with a deep SZE cluster survey, the ratio r can reveal independently of the normalization of the power spectrum whether we are living in a low-density flat universe or in an open universe. Within the flat universe scenario, the SZE cluster-normalized sigma (8) is studied, where sigma (8) is the rms density fluctuation within the top-hat scale 8 Mpc h(-1), where h is the Hubble constant in units of 100 km s(-1) Mpc(-1). A functional relation of sigma (8) proportional to Ohm (-0.13)(0) is found. Combined with the X-ray cluster-normalized sigma (8) proportional to Ohm (-0.52+0.13 Ohm0)(0), one can put constraints on both Ohm (0) and sigma (8) simultaneously.
What problem does this paper attempt to address?