Abstract:Throughout the last decade, many assistive robots for people with disabilities have been developed; however, researchers have not fully utilized these robotic technologies to entirely create independent living conditions for people with disabilities, particularly in relation to activities of daily living (ADLs). An assistive system can help satisfy the demands of regular ADLs for people with disabilities. With an increasing shortage of caregivers and a growing number of individuals with impairments and the elderly, assistive robots can help meet future healthcare demands. One of the critical aspects of designing these assistive devices is to improve functional independence while providing an excellent human-machine interface. People with limited upper limb function due to stroke, spinal cord injury, cerebral palsy, amyotrophic lateral sclerosis, and other conditions find the controls of assistive devices such as power wheelchairs difficult to use. Thus, the objective of this research was to design a multimodal control method for robotic self-assistance that could assist individuals with disabilities in performing self-care tasks on a daily basis. In this research, a control framework for two interchangeable operating modes with a finger joystick and a chin joystick is developed where joysticks seamlessly control a wheelchair and a wheelchair-mounted robotic arm. Custom circuitry was developed to complete the control architecture. A user study was conducted to test the robotic system. Ten healthy individuals agreed to perform three tasks using both (chin and finger) joysticks for a total of six tasks with 10 repetitions each. The control method has been tested rigorously, maneuvering the robot at different velocities and under varying payload (1-3.5 lb) conditions. The absolute position accuracy was experimentally found to be approximately 5 mm. The round-trip delay we observed between the commands while controlling the xArm was 4 ms. Tests performed showed that the proposed control system allowed individuals to perform some ADLs such as picking up and placing items with a completion time of less than 1 min for each task and 100% success.

[Design and Development of an Automatic Rotatory Chair for Canalith Repositioning Maneuver].

Control of a Rehabilitation Robotic Device Driven by Antagonistic Soft Actuators

Design And Modeling Of A Hydraulic Soft Actuator With Three Degrees Of Freedom

Design, Analysis, and Implementation of a Four-DoF Chair Motion Mechanism

Design and Control of a Multi-Axis Servo Motion Chair System Based on a Microcontroller

Design of an Automatic Rotatory Chair Prototype for BPPV Treatment.

Development of a redundant anthropomorphic hydraulically actuated manipulator with a roll-pitch-yaw spherical wrist

Design And Control Of A Sitting/Lying Style Lower Limb Rehabilitation Robot With Magnetorheological Actuators

Design and Validation of A Novel Planar 2R1T Remote Center-of-motion Mechanism Composing of Dual-Triangular and Straight-Line Linkages

Design and Analysis of Folding Mechanism for Intelligent Wheelchair-Stretcher Robot

Design and control of a sit-to-stand assistive device based on analysis of kinematics and dynamics

Design and Control of a Low-cost Non-backdrivable End-effector Upper Limb Rehabilitation Device

Mechanical Design and Trajectory Planning of a Lower Limb Rehabilitation Robot with a Variable Workspace

Control of a Wheelchair-Mounted 6DOF Assistive Robot With Chin and Finger Joysticks

Design and Simulation of a 3-DOF Dexterous Joint Actuator Based on Multi-Drive Hierarchical Output and Spherical Rotation Mechanism

Design and Workspace Analysis of a Differential Motion Rotary Style Breast Interventional Robot

Design of a Multi-position Computer Chair

Development of a robot system assisting artificial cervical disc replacement surgery.

Design and Analysis of a Multi-Joint Lower Limbs Rehabilitation Robot

An Endoscope Manipulating Robot Design

Design and analysis of a novel 3T1R four-degree-of-freedom parallel mechanism with infinite rotation capability