Abstract:In this study, we successfully synthesized a TiO2/CuO nanocomposite using the aqueous extract of Impatiens tinctoria A.rich. leaf extract as a capping, reducing, and stabilizing agent for the first time in an environmentally friendly, low-cost, straightforward, and sustainable technique. Numerous characterization techniques such as ultraviolet-visible diffuse reflectance spectroscopy (UV-vis-DRS), photoluminescence (PL), Raman spectroscopy, Fourier-transform infrared (FTIR), energy dispersive X-ray (EDX), transmission electron microscopy (TEM), X-ray diffraction (XRD), scanning electron microscopy (SEM), Brunauer-Emmett-Teller (BET), and high resolution TEM (HRTEM) were used to characterize the obtained TiO2/CuO nanocomposite. XRD verified that the TiO2/CuO nanocomposite has an average crystallite size of about 21 nm. The TEM result revealed an average particle size of 29 nm for the biosynthesized TiO2/CuO NC. The HRTEM analysis showed the presence of polycrystalline structures with the predominant lattice fringes 0.352 and 0.19 which were attributed to anatase phase TiO2 in the crystal plane of (101) and (200), respectively. The lattice fringes for monoclinic CuO were observed with values of 0.213 and 0.252 for the lattice planes of (111) and (111̅), respectively. The photoluminescence spectroscopic analysis revealed that the TiO2/CuO NC showed the lowest intensity compared to the pristine TiO2 and CuO indicating the reduction of exciton recombination in the case of the TiO2/CuO NC. The BET analysis showcased the formation of mesoporous materials with a surface area of 87.5 m2/g. The photocatalytic degradation performance of the biosynthesized TiO2, CuO, and TiO2/CuO nanomaterials against the potentially harmful MB dye was tested using the light source of a 150 tungsten-halogen lamp with a wavelength range of 360-2800 nm. The factors affecting photodegradation efficiencies like catalyst dose (20 mg), dye concentration(15 ppm), pH (9), and reaction time (90 min) were optimized for the degradation of the MB dye. The TiO2/CuO catalyst showed the highest degradation efficiency of 99% under the optimized conditions. The degradation rate of the MB dye in the presence of the TiO2/CuO NC was evaluated and found to be fitted to the pseudo-first-order kinetics with a rate constant of 0.03 min-1. The reusability test of the TiO2/CuO catalyst showed its good stability.

Synthesis and Characterization of TiO2–montmorillonite Nanocomposites and Their Application for Removal of Methylene Blue

TiO2 Intercalated Talc Nanocomposite: Preparation, Characterization, and Its Photocatalytic Performance

Efficient photocatalytic degradation of aqueous organic pollutants by using an advanced TiO2/Ti3C2/montmorillonite composites

Adsorption of Methylene Blue by Halloysite/MnFe2O4 Nanocomposites

Microstructure and Photocatalytic Decomposition of Methylene Blue by Tio2-Mounted Halloysite, A Natural Tubular Mineral

Biosynthesis of TiO2/CuO and Its Application for the Photocatalytic Removal of the Methylene Blue Dye

Photocatalyst-coated Carbon Microtube Electrodes: Preparation and Characterization of Their Properties and Photocatalytic Degradation of Methylene Blue.

photocatalytic degradation of TiO2 via incorporating Ti3C2 MXene for methylene blue removal from water

Photocatalytic Degradation of Methylene Blue by CNT/TiO2Composites Prepared from MWCNT and Titanium N-Butoxide with Benzene

Surface Morphology and Modulus, Wetting Behavior and Photocatalytic Activity of the TiO2 Coated Materials Based on PMMA/O-MMT Composite Microfibers

Removal of a Cationic Dye by Adsorption / Photodegradation Using Electrospun PAN / O-MMTComposite NanofibrousMembranes Coated with TiO 2

A Facile Method of Preparing Sandwich Layered TiO2 in Between Montmorillonite Sheets and Its Enhanced UV-light Photocatalytic Activity

A High-Stability Silica–clay Composite: Synthesis, Characterization and Combination with TiO2 As a Novel Photocatalyst for Azo Dye

Preparation and Photocatalytic Activity of Silver and TiO2 Nanoparticles/montmorillonite Composites

Synthesis of the ZnTiO3/TiO2 Nanocomposite Supported in Ecuadorian Clays for the Adsorption and Photocatalytic Removal of Methylene Blue Dye

Synthesis and characterization of montmorillonite – Mixed metal oxide composite and its adsorption performance for anionic and cationic dyes removal

Carbon/Mn3O4/SrTiO3 Microsphere Photocatalyst for the Efficient Removal of High-Concentration Methylene Blue from Water

Photocatalytic Decomposition Of Mb Solution By Cnt/Tio(2) Composites Prepared From Mwcnt And Titanium Source

Integrated Nanostructures of TiO2/g-C3N4/Diatomite Based on Low-Grade Diatomite as Efficient Catalyst for Photocatalytic Degradation of Methylene Blue: Performance and Mechanism

Synthesis of TiO2@lignin based carbon nanofibers composite materials with highly efficient photocatalytic to methylene blue dye

Solvothermal Preparation of Tio2/Montmorillonite and Photocatalytic Activity