Abstract:<p>Modern electronic devices with high heat flux increasingly exceed the capability of thermal management method. Two-phase thermal dissipation devices such as vapor chambers offer effective method for high heat flux cooling. Various new structural designs of vapor chambers are used as effective thermal control methods for high heat flux devices. However, the optimization criteria for the capillary wick structures are different. The combinations between the structural surface parameters and pore size of the capillary wick are different, while their influence on the heat transfer performance need to be studied. In this work, it is reported that the fabrication and thermal performance of vapor chambers with multi-layer sintered wicks and multi-artery wick design for liquid supply. We numerically and experimentally characterize the two types of sintered multi-artery wick for replenishing liquid and escaping vapor effectively with high heat flux. Three kinds of combinations of different copper particle sizes were applied to the sintered wicks in order to balance the liquid collecting rate and flow resistance. The copper particles of large particle size (60 μm /100 μm /150 μm) in the upper layer wick and copper particles of small particle size (30 μm /50 μm /100 μm) the lower layer wick were applied in the vapor chambers. In the present study, as an evaluation criteria for capillary wick designs, the relationship between surface porosity, surface area and critical heat flux was analyzed to obtain the experimental optimization of structural design and pore size combination as 50/100 μm. It was found that with similar multi-artery structure wicks, higher surface area porosity can effectively increase the critical heat flux of the vapor chambers. Judging from the experiment results, the minimum through-plane direction heat transfer resistance of the vapor chamber is 0.1426 K/W, the minimum in-plane direction heat transfer resistance is 0.016 K/W, while the critical heat flux of the vapor chamber is 262 W/cm<sup>2</sup>.</p>

Experimental Study of Evaporative Heat Transfer in Sintered Copper Bidispersed Wick Structures

An Experimental Study on Evaporative Heat Transfer in Bi-Dispersed Wick Structures

Characterization of evaporation and boiling from sintered powder wicks fed by capillary action

An Experimental study on Evaporation/Boiling Heat Transfer in Sintered Porous Wick

Experimental Studies on a Novel Thin Flat Heat Pipe Heat Spreader

Vapor chamber with two-layer liquid supply evaporator wick for high-heat-flux devices

Evaporation/boiling heat transfer on capillary feed copper particle sintered porous wick at reduced pressure

Experimental study on thermal performance of ultra-thin heat pipe with a novel composite wick structure

Experimental Investigation of Nano-Particle Deposited Wick Structure's Heat Transfer Characteristics

Characterization of capillary performance of composite wicks for two-phase heat transfer devices

Experimental Investigation of Effective Thermal Conductivity for LHP Wicks

D142 Experimental Study for Cooling Performance of Vapor Chamber Heat Spreader

Experimental Investigation Of Micro/Nano Heat Pipe Wick Structures

Experimental research on the thermal performance of a flat evaporator loop heat pipe with a new composite wick

Effect of low thermal conductivity wick on the performance of compact loop heat pipe

Experimental investigations on the effect of using distilled water in a heat pipe with copper screen wick

Effect of the working fluid transportation in the copper composite wick on the evaporation efficiency of a flat loop heat pipe

Sintered Wick Heat Pipes with Excellent Heat Transfer Capabilities—Case Study

Development of Sintered Ni-Cu Wicks for Loop Heat Pipes

Performance tests on triple composite mesh-groove-powder wicks in a visualizable flat-plate heat pipe

Analysis of thermal characteristics of the heat pipes with segmented composite wicks