Abstract:Presented in this study is investigation of dynamic behavior of a helical gear reduction by experimental and numerical methods. A closed-loop test rig is designed to measure vibrations of the example system, and the basic principle as well as relevant signal processing method is introduced. A hybrid user-defined element model is established to predict relative vibration acceleration at the gear mesh in a direction normal to contact surfaces. The other two numerical models are also constructed by lumped mass method and contact FEM to compare with the previous model in terms of dynamic responses of the system. First, the experiment data demonstrate that the loaded transmission error calculated by LTCA method is generally acceptable and that the assumption ignoring the tooth backlash is valid under the conditions of large loads. Second, under the common operating conditions, the system vibrations obtained by the experimental and numerical methods primarily occur at the first fourth-order meshing frequencies and that the maximum vibration amplitude, for each method, appears on the fourth-order meshing frequency. Moreover, root-mean-square (RMS) value of the acceleration increases with the increasing loads. Finally, according to the comparison of the simulation results, the variation tendencies of the RMS value along with input rotational speed agree well and that the frequencies where the resonances occur keep coincident generally. With summaries of merit and demerit, application of each numerical method is suggested for dynamic analysis of cylindrical gear system, which aids designers for desirable dynamic behavior of the system and better solutions to engineering problems.

The Analyzing Of The Dynamic Characteristic And The Design Of The Torque Measuring System In Extra-High Rotation Speed

Virtual Torque and Rotational Speed Measuring Device

Design and Analysis of Novel Torque Meter Based on Permanent Magnetic Clutch

The Study of Characteristics on the Longitudinal-Torsional Ultrasonic Motor

Experimental Study of Torque Measurement Based On FBG

Dynamic modeling and analysis of high-speed flexible planetary gear transmission systems

An Investigation On Dynamic Characteristics Of A High Speed Rotor With Complex Structure For Microturbine Test Rig

Dynamic Characteristic Analysis on the Direct Torque Ripple Testing System of PMSM

Dynamic Analysis Of High-Speed Face Gear Rotor System Applying Lumped Parameters

Hybrid Dynamic Modeling and Analysis of High-Speed Thin-Rimmed Gears

Torque Motor of the Turntable Key Components of the Ultra-Precision Optical Aspheric Machine Tool

Using multi-flexible body dynamic analysis and the Taguchi method to decrease the variation of output angular velocity in a double circular-arc harmonic gear drive

A Simple And Reliable Sensor For Accurate Measurement Of Angular Speed For Low Speed Rotating Machinery

Torque Measurement of High-Precision Reducer for Industrial Robot

Dynamic analysis of a helical gear reduction by experimental and numerical methods

Study of non-contact torque measurement of rotating shaft

Strategy to Decrease the Angle Measurement Error Introduced by the Use of Circular Grating in Dynamic Torque Calibration

Dynamics of Drive Axle System with Effects of Input Torque

Quasi-static Analysis Based on Generalized Loaded Static Transmission Error and Dynamic Investigation of Wide-Faced Cylindrical Geared Rotor Systems

Measuring System with Dual Magnetic Sensors for Outer-Rotor Type Torque Motor

Theoretical and Experimental Dynamics Analysis of Rotor-Bearing System Supported by Elliptical Bearings