Numerical Simulation of Electrocapillary Driven Flows

P. Zhou,C. W. Wu
DOI: https://doi.org/10.2174/1876402910901010057
2010-01-01
Micro and Nanosystemse
Abstract:The developed single-component multiphase lattice Boltzmann model (LBM) is used for studying an electro- capillary driven flow. The basic principle of the electrocapillary driven flow is to control the interface tension with electric potential. In the present paper, two pseudo-effective mass of the solid wall are adopted to control the interfacial tension of gas-solid and liquid-solid respectively. This method can independently control the liquid-solid interfacial tensions which is in turn controlled by the applied electric voltage in the electrocapillary driven flow. The numerical results show that the method can simulate the contact angle saturation phenomenon in electrowetting and the capillary flow considering the dy- namic contact angle (DCA). We also find here the cosine of the DCA is proportional to the capillary number and the pre- diction error of the liquid level (in single capillary tube) is close to the inverse of the adopted density ratio.
What problem does this paper attempt to address?