Abstract:Supported reagents have been widely used in organic synthesis for some 25 years and their importance is likely to increase as a result of new environmental legislation and the drive towards clean technology. While many supported reagents are stoichiometric in reactions the successful development of genuinely catalytic materials greatly enhances their value especially in liquid phase, typically fine chemical syntheses. Achieving an understanding of the nature of these fascinating materials is also an important aspect of their development and is essential if their true potential is to be realised. Solid acids are the most widely studied of supported reagents and their use as more environmentally acceptable replacements for conventional Bronsted and Lewis acids is likely to become increasingly important. Clayzic is a good example of an environmentally friendly catalyst with particular value as an alternative to the hazardous reagent aluminium chloride in Friedel-Crafts reactions. The structure and properties of this catalyst are, however, poorly understood. X-Ray diffraction studies show that thermal treatment of either clayzic or its base material K10 results in the loss of any montmorillonite crystallinity that remained after the acid treatment of tonsil 13 used to form K10. Thermal treatment of clayzic also results in a steady increase in the surface area of the material. While this is also consistent with structural changes the increase is also likely to be partly due to the dehydration allowing the non-polar adsorbate to enter more of the polar regions of the material. These polar regions can be identified as mesopores created by the acid treatment of the clay and in which the zinc ions largely reside. Spectroscopic titration of the acid sites in clayzic show these to be largely Lewis acid in character. Thus clayzic owes its remarkable Friedel-Crafts activity to the presence of high local concentrations of zinc ions in structural mesopores. Relative reaction rates for the clayzic catalysed benzylation of alkylbenzenes also reveal the importance of these highly polar mesopores. Considerable rate enhancements can be achieved by thermally activating the catalyst and this can be largely attributed to the dehydration of the catalyst enabling better partitioning of the alkylbenzenes into the mesopores. Clayzic can be considered as being a large pore molecular sieve but where the sieving of molecules is controlled more by molecular polarities/polarisibilities than by molecular shape.

Enhanced Selectivity in the Preparation of Linear Alkylbenzenes Using Hexagonal Mesoporous Silica Supported Aluminium Chloride1

Environmentally Friendly Catalysis Using Supported Reagents: Enhanced Selectivity Without Loss in Activity in the Alkylation of Benzene Using Hexagonal Mesoporous Silica (Hms)-Supported Aluminium Chloride†,1

Preparation of PtCl_6~(2-) Intercalated Mg/Al-hydrotalcite Catalyst and Its Catalytic Activities for the Hydrosilylation of Olefins

Preparation of PtCl62-Intercalated Mg/Al-hydrotalcite Catalyst and Its Catalytic Activities for the Hydrosilylation of Olefins

Study on Redistribution of Methyltrichlorosilane and Trimethylchlorosilane over AlCl3 Supported Catalyst

Synthesis of Alkylbenzene from Medium-Chain Olefins Catalyzed by an Acidic Ionic Liquid and the Surface Properties of Their Sulfonate

A Silica Supported Cobalt (II) Salen Complex As Efficient and Reusable Catalyst for the Selective Aerobic Oxidation of Ethyl Benzene Derivatives

Mesoporous Aluminosilicate Catalysts for the Selective Isomerization of n-Hexane: The Roles of Surface Acidity and Platinum Metal.

A New Solid Acid-Based Route to Linear Alkylbenzenes

Aluminum Impregnated Silica Catalyst for Friedel–Crafts Reaction: Influence of Ordering Mesostructure

MCM-56 stabilization synthesis using auxiliary tetraethylammounium ions: Its role to inhibit surface Si-O-Al bridged linkage and retain highly delaminated structure

Post-treatment with Ammonium Hexafluorosilicate: an Effective Way to Synthesize High Silica MCM-22 Zeolite

Synthesis and catalytic properties of mesoporous alumina supported aluminium chloride with controllable morphology, structure and component

Catalytic Oxidation of Alkyl Aromatics Using a Novel Silica Supported Schiff Base Complex

Keynote Article. Environmentally Friendly Chemistry Using Supported Reagent Catalysts: Structure–property Relationships for Clayzic

Sustainable Sulfonic Acid Functionalized Tubular Shape Mesoporous Silica as a Heterogeneous Catalyst for Selective Unsymmetrical Friedel-Crafts Alkylation in One Pot

Environmentally Friendly Liquid Phase Oxidation: Enhanced Selectivity in the Aerial Oxidation of Alkyl Aromatics, Epoxidations and the Baeyer-Villiger Oxidation Using Novel Silica Supported Transition Metal Ions

Selective Alkylation of Benzene with Methanol to Toluene and Xylene over H-ZSM-5 Zeolites: Impact of Framework Al Spatial Distribution

Preferential Siting of Aluminum Heteroatoms in the Zeolite Catalyst Al‐SSZ‐70

Achieving long-lived MWW zeolite catalyst for alkylation of benzene with 1-dodecene: Insights into confinement effect of surface cavities and underlying mechanism

Polymerisations in mesoporous environments