Abstract:In the present work the rheological, thermo-mechanical, microstructural, and wetting characteristics of cement mortars with recycled expanded polystyrene (EPS) were analyzed. The samples were prepared after partial/total replacement of the conventional sand aggregate with EPS having different grain size and size distribution. Lightness and thermal insulation were relevant features for all the bare EPS composites, despite the mechanical strengths. Specifically, EPS based mortars were characterized by higher thermal insulation with respect to the sand reference due to the lower specific mass of the specimens mainly associated with the low density of the aggregates and also to the spaces at the EPS/cement paste interfaces. Interesting results in terms of low thermal conductivity and high mechanical resistances were obtained in the case of sand-EPS mixtures although characterized by only 50% in volume of the organic aggregate. Moreover, sand-based mortars showed hydrophilicity (low WCA) and high water penetration, whereas the presence of EPS in the cement composites led to a reduction of the absorption of water especially on the bulk of the composites. Specifically, mortars with EPS in the 2–4 mm and 4–6 mm bead size range showed the best results in term of hydrophobicity (high WCA) and no water penetration in the inner surface, due to low surface energy of the organic aggregate together with a good particle distribution. This was indicative of cohesion between the ligand and the polystyrene as observed in the microstructural detections. Such a property is likely to be correlated to the observed good workability of this type of mortar and to its low tendency to segregation compared to the other EPS containing specimens. These lightweight thermo-insulating composites can be considered environmentally sustainable materials because they are prepared with no pre-treated secondary raw materials and can be used for indoor applications.

Preparation of Adhesives from Recycled Expandable Polystyrene(EPS) Foams

Water‐soluble/dispersible Cationic Pressure‐sensitive Adhesives. II. Adhesives from Emulsion Polymerization

Study on Improve Interface Tensile Adhesive Property of Extruded Polystyrene Board with Acrylate Emulsion

Surface Enrichment by Conventional and Polymerizable Sulfated Nonylphenol Ethoxylate Emulsifiers in Water-Based Pressure-Sensitive Adhesive

Production and characterization of an ecofriendly polystyrene waste adhesive made with toluene–acetone solvent

Preparation of recycled graphite/expanded polystyrene by a facile solvent dissolution method

An eco‐friendly and high shear strength adhesive from catechol‐modified polyethyleneimine

Emulsion Semi-Batch Terpolymerization Process Using Hybrid Emulsifiers for Synthesizing New Emulsion Pressure Sensitive Adhesives (EPSAs)

Polystyrene Foamed Plastic Recovery and Regeneration Process Research

The water-soluble fraction of extracellular polymeric substances from a resource recovery demonstration plant: characterization and potential application as an adhesive

Recycled Expanded Polystyrene as Lightweight Aggregate for Environmentally Sustainable Cement Conglomerates

Preparation optimization by response surface and performance characterization of PEG-urea-dialdehyde starch adhesive

Recycling of waste expanded polystyrene concrete in lightweight sandwich panels and structural applications

Reduction of polystyrene/polyurethane plastic wastes from the environment into binders for water-resistant emulsion paints

A Separable Paper Adhesive Based on the Starch-Lignin Composite

Solvent-Free and Recyclable Polyether/Polyphenol Supramolecular Adhesives with Robust, Water- and Low-Temperature-Resistant Properties

Giving superabsorbent polymers a second life as pressure-sensitive adhesives

Preparation of flame retardant and thermal insulation polystyrene foams via high internal phase emulsion template

Preparation of starch polyols adhesive

Recoverable Solvent-free Small Molecular Supramolecular Pseudoeutectic Adhesives with a Wide Temperature Range