Abstract:This study investigated the effectiveness and mechanisms of a novel composite adsorbent, prepared through in situ coating and regenerated through in situ embedding with Fe-Mn binary oxides onto porous diatomite (FMBO-DE), for the simultaneous removal of As(III) and As(V) from drinking water. FMBO-DE was prepared in situ by interactions between equivalent amount of KMnO4 and FeSO4 (3:1) with suspended porous diatomite. Zeta potential analysis showed the zero point of charge was pH 7.0, slightly higher than Fe-Mn binary oxides (pH 6.1). No X-ray diffraction peaks were observed, confirming that FMBO-DE was amorphous; SEM/EDX analysis showed the surface elemental ratio of Fe to Mn was 3:1, indicating that ferric and manganese oxides were evenly homogeneous in Fe-Mn binary oxides. Kinetics studies showed As was quickly removed by FMBO, up to 80% of equilibrium capacity within initial 60 minutes. Additionally, it exhibited strong potential for removing both As(III) and As(V), with maximum adsorption capacities as high as 350 mgAs(III) /g FMBO and 200 mgAs(V)/g FMBO, respectively. It was noteworthy that FMBO showed higher potential of removing As(III) than As(V). Continuous column tests demonstrated significant removal of both As(III) and As(V). At an initial As concentration of 100µg L-1 and empty bed contact time of 5 min, freshly prepared FMBO-DE could treat 3000 bed volume (BV) of As(III) and 2000 BV of As(V) and the effluent As concentration was consistently below 10 μg L-1. The in situ embedded regeneration processes obviously increased the capability of removing As from water. After three regenerations, the adsorbing potential was as high as 4500 BV of As(III) and 3100 BV of As(V), respectively.

Study on Adsorption of COMn on Attapulgite Activated Carbon Composite Material from Aqueous Solution

Research on The Adsorptive Propeties of Attapulgite Activated Carbon Composite Material to Congo Red

The adsorption of Sb(Ⅲ) in aqueous by KMnO_4-modified activated carbon

Carboxylmethyl Konjac Glucomannan Conjugated Polydopamine Composites for Pb(II) Removal.

Adsorption of Aquatic Cd(2+)using a Combination of Bacteria and Modified Carbon Fiber

Adsorption Characteristics of Methylene Blue Onto the N-succinyl-chitosan- G -Polyacrylamide/attapulgite Composite

Effects of Attapulgite Addition on the Mechanical Behavior and Porosity of Cement-Based Porous Materials and Its Adsorption Capacity

Preparation and adsorption property of attapulgite/carbon nanocomposite

Adsorption of Pb2+ and Cd2+ from Aqueous Solutions by Lignocellulose-G-acrylic Acid/acrylamide/montmorillonite Nanocomposites

Graphene oxide/polydopamine modified montmorillonite/carboxymethyl chitosan composite aerogel for efficient removal of Pb 2+ , Cu 2+ , and Cd 2+ : Adsorption behavior, mechanism and DFT study

Adsorption performance and physicochemical mechanism of MnO2-polyethylenimine-tannic acid composites for the removal of Cu(II) and Cr(VI) from aqueous solution

Novel Composite Adsorbents Preparation Through in Situ Coating and Embedded Regeneration for the Simultaneous Removal of As(III) and As(V) from Drinking Water

Removal of Methylene Blue from Aqueous Solution Using Chitosan-G-poly(acrylic Acid)/montmorillonite Superadsorbent Nanocomposite

Cost-effective microwave-assisted hydrothermal rapid synthesis of analcime-activated carbon composite from coal gangue used for Pb2+ adsorption

Fabrication of nitrogen-doped carbon dots biomass composite hydrogel for adsorption of Cu (II) in wastewater or soil and DFT simulation for adsorption mechanism

Study on the Removal of Copper Ions from Water Using Eco-Friendly Attapulgite/Chitosan Composites

Synthesis and Characterization of Amino-Grafted Attapulgite/graphene Oxide Nanocomposites and Their Adsorption for Pb(II) Removal

Preparation and adsorption of Cd2+ of attapulgite modified by AMPS

Adsorption of Rhodamine B in Aqueous Solution by Mg/CS Composite Modified Attapulgite

Preparation of montmorillonite nanocomposite and its adsorption

Adsorptive Removal of Cationic Dye from Aqueous Solution by Graphene Oxide/Cellulose Acetate Composite