Total hip replacement revision with a fluted,tapered,modular stem

Luo Yuan,Sun Jun-ying,Li Yong-wang,Yang Mao-wei
DOI: https://doi.org/10.3969/j.issn.1673-8225.2011.04.003
2011-01-01
Abstract:BACKGROUND:Modular femoral stem revision prosthesis is theoretically considered to overcome disadvantages of cemented femoral stem or biological fixed non-modular femoral stem.Some studies report favorable effect of modular femoral stem.OBJECTIVE:To summarize the experience on the revision total hip replacement with a fluted,tapered,modular stem.METHODS:From May 2000 to August 2005,19 patients (21 hips) undergoing total femoral revision were selected from First Affiliated Hospital of Soochow University.All were diagnosed as aseptic loosening of stems coupled with bone loss prior to revision.Pre-revision femoral defects were classified according to the system of Paprosky,including 4(19%) of type Ⅱ femoral bone loss,14(67%) of type Ⅲ a femoral bone loss,and 3(14%) of type Ⅲ b femoral bone loss.The revision was performed using the fluted,tapered,modular stem.The revision effect was observed.RESULTS AND CONCLUSION:All stems achieved primary stability.No infection or dislocation was found.The Harris Hip Score at the latest follow-up maintained at 92.2±3.5.X-ray showed general bone ingrowth and bone stability in 20 hips(95%),and fiberous stability in 1 hip(5%).All of the cases showed bone restoration in the proximal defect zone after bone graft without increased radiolucent lines.Anterioposterior and lateral X-ray showed that femoral stem intramedullary filling rate was 80% and 70% in 18 hips(86%),<80% and 70% in 3 hips(14%).All stems were in neutral position and the average subsidence was 2.4mm.There were no re-revisions of the femoral stem for any reason.Revision with fluted,tapered,modular stem can achieve satisfied results.But we must pay more attention to the following factors:1)Hand reaming was important to reduce fracture rate;2)appropriate cannel filling and adjustment of proximal component can prevent subsidence and dislocation;3)proximal cavity reconstruction around the Morse taper junction.
What problem does this paper attempt to address?