Abstract:Jacket foundation is widely applied in development of offshore wind power, oil and gas. The failure of a jacket foundation is mainly caused by the lateral loads of wind, wave, current, earthquake, etc. Two groups of centrifugal model tests on a jacket foundation loaded along the border and the diagonal respectively are carried out in saturated sand to investigate the distribution of internal forces, difference of soil resistance and deformation characteristics for piles. The test results show that the piles of a jacket foundation will be pulled out more easily under diagonal loading. Moreover, compared with the up-lifted pile, the downward-pushed pile bears larger shear force and the maximum negative bending moment at the top, and larger maximum positive bending moment of the pile shaft, and shows basically the same lateral deflection. As for a 5.8-diameter spaced jacket foundation, because of the pile group effect and the up-lifting force which reduces the effective stress in soil around the pile, the resistance of shallow layer soils around the up-lifted pile is 60%of that around the downward-pushed pile within the depth of 2.5-diameter below mudline under diagonal loading, which is only 40% of that under diagonal loading. These differences of shear force, the maximum negative bending moment, axial force at the top and the maximum positive bending moment of the pile shaft between the downward-pushed pile and the up-lifted pile under diagonal loading are also more obvious than those under diagonal loading. In comparison with these results of centrifugal model tests on a large-diameter single pile under lateral loads, it is found that the soil resistance for a single pile is between that for the up-lifted pile and the downward-pushed pile of a jacket foundation at the same depth.

A Dynamic Loading Device for Suction Foundations in Centrifuge Modeling

An Investigation into the Lateral Loading Response of Shallow Bucket Foundations for Offshore Wind Turbines Through Centrifuge Modeling in Sand

Centrifuge modeling of suction bucket foundations for platforms under ice-sheet-induced cyclic lateral loadings

Centrifuge model test on suction caisson foundation in soft clay subjected to lateral loads

Centrifuge modelling on tetrapod jacket foundation subjected to lateral loads

Failure Mechanism of Suction Foundation of Offshore Platform Based on Centrifuge Modeling and Limit Analysis

Centrifuge Modelling of Suction Anchor Subjected to Inclined Load in Soft Clay

Centrifuge and Numerical Simulation of Offshore Wind Turbine Suction Bucket Foundation Seismic Response in Inclined Liquefiable Ground

Physical modelling of suction foundations of TLPs under horizontal loads

Numerical modelling on effect of loading rate on uplift behavior of suction caissons

A Numerical Study on the Lateral Loading Behaviour of Offshore Tetrapod Piled Jacket Foundations in Clay

Centrifuge Modelling of Lateral Cyclic Behaviour of a Tetrapod Piled Jacket in Soft Clay

Development of a dynamic loading device for suction pile in centrifuge

Behavior of Large Diameter Cylinders under Lateral Loads

Centrifugal Model Test of an Offshore Wind Turbine Foundation on Saturated Sand Ground

Centrifuge test on the deformation of bucket foundation under horizontal vibration load

Microscopic insights into suction bucket installation in sand: Coupled coarse-grained CFD-DEM simulations

Experimental study on the bucket foundation responses under vertical vibration load

Dynamic model test on monopile for offshore wind turbine under jointed lateral environmental load and seismic load

RESPONSES OF SUCTION BUCKET IN FINE SAND UNDER HORIZONTAL DYNAMIC LOADING

Three dimensional limit analysis of suction bucket foundations