Abstract:This paper presents the initial developments of new hardware devices targeted for CAN (Controller Area Network) bus communications in forest machines. CAN bus is a widely used protocol for communications in the automobile area. It is also applied in industrial vehicles and machines due to its robustness, simplicity, and operating flexibility. It is ideal for forestry machinery producers who need to couple their equipment to a machine that allows the transportation industry to recognize the importance of standardizing communications between tools and machines. One of the problems that producers sometimes face is a lack of flexibility in commercialized hardware modules; for example, in interfaces for sensors and actuators that guarantee scalability depending on the new functionalities required. The hardware device presented in this work is designed to overcome these limitations and provide the flexibility to standardize communications while allowing scalability in the development of new products and features. The work is being developed within the scope of the research project “SMARTCUT—Remote Diagnosis, Maintenance and Simulators for Operation Training and Maintenance of Forest Machines”, to incorporate innovative technologies in forest machines produced by the CUTPLANT S.A. It consists of an experimental system based on the PIC18F26K83 microcontroller to form a CAN node to transmit and receive digital and analog messages via CAN bus, tested and validated by the communication between different nodes. The main contribution of the paper focuses on the presentation of the development of new CAN bus electronic control units designed to enable remote communication between sensors and actuators, and the main controller of forest machines.

Test on The DIN9684 Interface of FieldStar Precision Agriculture System

Multi-node data acquisition and analysis system for the development of AT electronic control unit.

Application design of CAN bus in tractor test bench

Study on Farm Field Information On-Line Measurement Instrument

CAN Application-layer Protocol Design of Intelligent Monitoring System for Cotton-picking Machine

Research and realization of control network for agriculture and forestry machinery based on CAN

Design and Implementation of An On-board Measurement System based on CAN Bus

Research on the plant energy monitoring system based on CAN bus

Control System of Combine Harvester Threshing Cylinder Based on CAN Bus

Design of CAN Bus Communication Interfaces for Forestry Machines

A NEW Data Acquisition Method to CAN and 1553B Armored Vehicle Buses

Applied Fieldbus into Communication Systems in ITS

CAN Interface Steering Wheel Angle and Torque Acquisition System with 16-Bit A/D Converter

CAN bus experimental system in teaching practice

Hardware Design of Data Acquisition Based on CAN

Study on System of Data Acquisition and Analysis in FMS

Application of 1-Wire BUS in Data Acquisition in Precision Agriculture

Network Technology of Intelligent Instruments Based on CAN Bus

Design and Implementation of Field Bus Device Management System Based on HART Protocol

Design and Implementation of the Measurement and Control System Based on Can Bus in Modern Greenhouse

The Design of Field Information Detection System Based on Microcomputer.