Abstract:This study establishes detailed neural network modeling procedures for the combustion optimization of a power generation unit, equipped with a Selective Catalytic Reduction (SCR) system. In particular, artificial intelligence neural networks were applied due to its capability in treating large pools of data of great nonlinearity. The objective of this study was to reduce nitrogen oxide (NOx) emissions in the stack gas, lower the cost of emissions compliance and minimize the net unit heat rate at this power generation unit at full-load conditions. These procedures include building a database with real coal power plant operating data, modeling the database and using the genetic algorithm to optimize the operating conditions. The operation is optimized with respect to the steam temperature, selective catalyst reactor, and separated over-fire air conditions. Verifications of the results demonstrated that by carrying out the reported study, the pollutant concentrations of the boiler are significantly decreased and the catalyst layer is effectively preserved, while the operation can be maintained stable near the full-load condition. It was found that the average ammonia (NH3) flow to the SCR under optimized conditions was 229 kg/h, while the average NH3 flow under non-optimal operational conditions was 260 kg/h, resulting in a reduction in NH3 consumption of approximately 12 % from the non-optimized operational condition. In the meantime, the SCR inlet (boiler exit) NOx was reduced from 523 mg/Nm3 (non-optimized operational condition) to 444 mg/Nm3 (optimized operational condition), which represent about 15 % reduction. Based on the experience with SCR from manufactures and operators, the SCR catalyst life expectancy has a direct relationship with the SCR inlet NOx concentration and NH3 injection rate. The lower the NOx concentration at the SCR inlet and the less the NH3 injection rate, the longer of the SCR catalyst life will be. Thus, it is expected that the SCR catalyst layer replacement frequency could be reduced by 10 to 20 % over the normal catalyst replacement cycle, while meeting the same environmental NOx emissions limit. Additionally, a Delta Heat Rate was also calculated using best available data from the optimized operational conditions, including boiler load, boiler excess oxygen (O2), fly ash unburned carbon and attemperation flow. Results were compared with the average Delta Heat Rate calculated from baseline tests. It was found that the average Delta Heat Rate from baseline tests are −60 kJ/kWh, while the delta heat rate from the optimized operation condition hours is −118 kJ/kWh. This represents about 0.57 % improvement on unit heat rate from the baseline average.

Modeling and Optimization of the Nox Emission Characteristics of A Tangentially Fired Boiler with Artificial Neural Networks

Multi-objective Optimization of the Coal Combustion Performance with Artificial Neural Networks and Genetic Algorithms

On the Use of Artificial Neural Networks to Model the Performance and Emissions of a Heavy-Duty Natural Gas Spark Ignition Engine

Combustion Optimization Study of Pulverized Coal Boiler Based on Proximal Policy Optimization Algorithm

Modeling and Coordinative Optimization of Nox Emission and Efficiency of Utility Boilers with Neural Network

AN ARTIFICIAL NEURAL NETWORK MODEL ON NO_x EMISSION PROPERTY OF A HIGH CAPACITY TANGENTIALLY FIRING BOILER

The Utility Boiler Low NOx Combustion Optimization Based on ANN and Simulated Annealing Algorithm

[Predicting Low NOx Combustion Property of a Coal-Fired Boiler].

Optimizing pulverized coal combustion performance based on ANN and GA

Modeling and optimization of the NO X generation characteristics of the coal-fired boiler based on interpretable machine learning algorithm

Combustion optimization of ultra supercritical boiler based on artificial intelligence

Nox Emission Model for Coal-Fired Boilers Using Principle Component Analysis and Support Vector Regression

Combining Neural Network and Genetic Algorithms to Optimize Low Nox Pulverized Coal Combustion

Modeling NOx emissions from coal-fired utility boilers using support vector regression with ant colony optimization

Computational intelligence approach for NOx emissions minimization in a coal-fired utility boiler

NOx Prediction Model for Multi-coal Admixing Combustion in Boiler

Combining Support Vector Regression and Ant Colony Optimization to Reduce NOx Emissions in Coal-Fired Utility Boilers

Experimental Investigation of Operating Strategy of Low NOx, High Efficiency Coal-Fired Utility Boilers

Large capacity utility boiler low NOx combustion optimization technology using genetic algorithms

Modeling and Reduction of NOX Emissions for a 700 MW Coal-Fired Boiler with the Advanced Machine Learning Method

Combustion optimization of a coal-fired power plant boiler using artificial intelligence neural networks