Abstract:Abstract The collapse of dangerous rock masses, either due to natural causes (such as weathering by rain) or anthropogenic factors (such as engineering construction in the rock area), poses a threat to both life and property. Therefore, investigating deformation failure mechanisms and determining the movement characteristics of the rock masses after collapse can provide practical guidance for conducting linear projects while taking adequate measures to prevent the collapse. In this study, a dangerous rock mass on the right side of the Yuanhou Toll Station of the Rongzun Expressway was used to study the deformation and failure mechanism of near-horizontal and thick layer with thin-layer columnar dangerous rock masses in the Chishui red bed area. A high-definition 3D-surface model was generated by using unmanned aerial vehicle (UAV) tilt photography technology to obtain an aerial image of dangerous rock masses with spatial coordinates in the research area. The three-point method was used to interpret the structural surface of the dangerous rock mass based on the 3D model. A model for the deformation and failure of dangerous rock masses was developed via an engineering geological analysis. We simulated and analyzed the cause of deformation and failure of dangerous rock masses using FLAC3D software. In addition, the motions of rock fall were studied by performing simulations using Rockfall software. From the interpretation of the 3D model of the UAV, the dangerous rock mass developed two sets of dominant structural planes that were nearly vertical and perpendicular to the stratum level, cutting the rock mass into cuboids. Based on the analysis of a stereographic projection, the dangerous rock mass was in an unstable state. The results showed that the dangerous rock mass had a high stress concentration in the middle and lower soft rock, which is likely due to dumping collapse under self-weight and differential weathering. Moreover, rock fall has a 60% probability of causing damage to the road below the rock mass if it collapses, threatening the safety of passing vehicles and people’s lives and property.

Study on Numerical Simulation on Roof Falling Danger Grade of Shallow Depth Strata

Deformation Failure Mechanism and Motion Laws of Near-horizontal Thick-layer with Thin-layer Columnar Dangerous Rock Mass in the Chishui Red Bed Area

Study on Relationship Between Potential Caving Hazard Level and Stable Rock Layer Position

Numerical Study of the Mechanism of Dense Drillings for Weakening Hard Roofs and its Application in Roof Cutting

Study on Key Stratum of Overlying Strata in 24th Mining Area of Zhouyuanshan Coal Mine

Analysis on Roof Falling Hidden Danger Grading of Mining Gateway

Numerical simulation and support research on the instability of deep-steeply inclined coal roadway with soft floor

Numerical Simulation Modeling and Calculation Analysis on Stope Roof Stability under the Complex Geological Conditions in Deep Mining

Numerical Simulation about Roadway Support with Soft and Compound Roof

Numerical stability assessment of a mining slope using the synthetic rock mass modeling approach and strength reduction technique

Disaster Control of Roof Falling in Deep Coal Mine Roadway Subjected to High Abutment Pressure

Numerical Simulation of Deformation and Fracture Laws for Soft Rock Roadway in Deep Shaft Large Section

Study on the dynamic response and roadways stability during mining under the disturbance of hard roof break

Study on the Spatiotemporal Dynamic Evolution Law of a Deep Thick Hard Roof and Coal Seam

Study on Failure Characteristics and Control Technology of Roadway Surrounding Rock under Repeated Mining in Close-Distance Coal Seam

Study on Failure Law and Failure Depth of Floor in Deep Mining

Study on the controller factors associated with roof falling and ribs spalling in deep mine with great mining height and compound roof

Characteristics of Strata Behavior and Differentiated Control of Fully Mechanized Mining Working Face with Abnormal Roof

Study on the effect of rock stratum structure on the stability of weakly cemented layered floor and the floor control measures ‐A case study of Meihuajing Mine

Multi‐factor analysis of roof deformation and reasonable determination of the unsupported distance of a coal roadway heading face based on response surface method

Field and Numerical Study on Deformation and Failure Characteristics of Deep High-Stress Main Roadway in Dongpang Coal Mine