The Fe-TiO2 with High Thermal Stability Prepared by Supercritical Ethanol Drying

LU Han-feng,ZHOU Ying,XU Bo-qing,CHEN Yin-fei,LIU Hua-zhang
DOI: https://doi.org/10.16084/j.cnki.issn1001-3555.2008.01.007
2008-01-01
Abstract:The high thermal stability anatase TiO2 doped with different Fe3+ contents were synthesized by coprecipitation of the aqueous solution of TiCl4 and Fe(NO3)3 followed by drying in supercritical ethanol.The textures and microstructure of the samples were characterized with XRD,BET,TG and TEM.The results show that there are no effects of Fe3+ on the BET,particles sizes and morphology of the samples after calcinations at 500℃.Even treated at 800℃ samples was highly resistant to phase transformation from anatase to rutile.However,Small amount of Fe3+(0.5at%) in TiO2 will replace Ti4+ in lattice which result in an increase in the lattice strain and the surface tension.The excess Fe3+(0.5at%) in TiO2 shows little effect on lattice parameters and lattice strain,but they was more easy to form large particles for the iron oxide enriching on surface after the thermal treatment.The Diffuse reflectance UV-Vis spectra(DRS) shows that the onset of the absorption band shifted toward higher wavelength with increasing modification level.When the samples was further treated at 800℃,The doped TiO2 showed enhanced adsorption in the range of 400~670nm.The photoactivity of the samples uner UV light were evaluated by photocatalytic degradation of methyl orange(MO) in aqueous solution.The maximum photodegradation rate was obtained in the undoped anatase TiO2.The lower photocatalytic performance of the Fe-doped samples may be ascribed to the richer bulk lattice defects and the larger particle size.
What problem does this paper attempt to address?