Abstract:Synthetic Aperture Radar Interferometry (InSAR) time series analysis technique gradually becomes an important a-pproach to obtain the long-term trend of surface deformation. It chooses a series of SAR images and establishes the corresponding model to extract the surface deformation. Currently, the InSAR time analysis technique is capable to improve the decorrelation and atmospheric delay in InSAR, therefore it has been widely used in many fields, including the urban ground deformation caused by the exploitation of underground resources, the mining field surface deformation caused by exploitation of mineral and natural gas, and the natural surface deformation caused by earthquake, volcano or landslide. Among different practical cases, selecting an appro-priate method to capture the high coherent target is the fundamental step in getting the accurate and reliable surface deformation in-formation. In this paper, we analyze the theoretical models of Permanent Scatterers (PS) and Distributed Scatterers (DS) and the dif-ferences of characteristics between the PS and DS point types. And we summarize the advantages and disadvantages of different high coherent target selection methods from the perspectives of SAR echo signal and InSAR time series analysis. Dispersion of am-plitude is the most widely used method and the phase analysis method is more suitable for further selecting the points of PS. For the method of signal-to-clutter ratio, it is more applicable to select the PS candidates. The correlation coefficient method is only adap-tive to a few SAR data. And for DS selection, the improved average temporal coherence method is more representative than the dis-persion of amplitude difference method and the average temporal coherence method. In addition, this paper chooses some of the western part of Altyn Tagh Fault as the study area. And we verify the feasibility of the typical PS and DS selection methods to the real surface of the study area. The experimental results show that the DS method is more applicable than the PS method in non-ur-ban area, and we obtain the deformation rate of Altyn Tagh Fault as well. Through these analyses, we provide the theory basis for se-lecting the appropriate methods in different research applications within different geographical areas.

Theoretical Models, Characteristics and Suitable Applied Areas for D-InSAR and PS-InSAR

Application Potential of Differential SAR Interferometry in Land Subsidence Spatial-Temporal Data Capturing

Landslide Movement Monitoring with InSAR Technologies

Integrated Use of Interferometric SAR Data and Levelling Measurements for Monitoring Land Subsidence

Mapping surface displacement based on D-InSAR technique

INTERFEROMATIC SAR(INSAR) AND ITS APPLICATION TO EXTRACTION OF GEOLOGICAL INFORMATION

A Study of PS-InSAR Method for Small Area Urban Land Subsidence.

Applications of SAR Interferometry in Earth and Environmental Science Research

Advances in interferometric synthetic aperture radar (InSAR) in earth system science

Dynamic Landslide Risk Assessment with InSAR Techniques – A Case Study

Long-Term Remote Monitoring of Ground Deformation Using Sentinel-1 Interferometric Synthetic Aperture Radar (InSAR): Applications and Insights into Geotechnical Engineering Practices

Land Subsidence Monitoring Method in Regions of Variable Radar Reflection Characteristics by Integrating PS-InSAR and SBAS-InSAR Techniques

InSAR Phase Denoising: A Review of Current Technologies and Future Directions

Application of D-InSAR Technology in Monitoring Land-surface Subsidence After an Earthquake

Land deformation monitoring in the Taiyuan area based on PS-InSAR

Monitoring Potential Geological Hazards with Different InSAR Algorithms: The Case of Western Sichuan

Monitoring, Prediction, and Evaluation of Mountain Geological Hazards Based on InSAR Technology

Comparison Research of High Coherent Target Selection Based on InSAR Time Series Analysis

Optimal selection and application analysis of multi-temporal differential interferogram series in StaMPS-based SBAS InSAR

Atmospheric Effects on InSAR Measurements and Their Mitigation

A Modified Interferometric Phase Model for Imaging Integral Angle Applied to UAV InSAR