Abstract:Green liquor from alkali recovery process was used in the pretreatment of poplar wood chips. The delignification reaction course and the consumption process of alkaline during subsequent kraft pulping were studied. After green liquor pretreatment poplar wood chips were cooked under conventional kraft cooking conditions. Black liquor from cooking process was used to analyze the lignin content and the concentration of NaOH and Na2S by acid precipitation method and titration method, respectively. For kraft pulping after green liquor pretreatment, the yield was 73.1%, delignification rate was 32.54%. Contrasted to the traditional kraft pulping, delignification velocity was almost steady during the cooking process. On the initial delignification phase, delignification rate was 14.52%. On the bulk delignification phase and residue delignification phase, delignification rates were 42.62% and 3.41%, respectively. Compared to the traditional kraft pulping, delignification rates of three delignify phases reduced by 3.55, 19.38 and 9.11 percent points, respectively. NaOH was almost consumed at the initial delignify phase and bulk delignify phase with the consumption of 57.71% and 42.29%, respectively. The concentration of Na2S decreased firstly, and reached to a minimum of 1.09 g/L in 1.25 h, but after 1.25 h, since sulfur precipitated from ligninsulfonate, the concentration of Na2S began to increase gradually. Kraft pulping with green liquor pretreatment could not only improve the selectivity of delignification, but also reduce the degradation of carbohydrates. The total cooking yield was 50.8%, increased by 2.9 percent points,compared to the traditional kraft pulping.

Study on Kraft Pulping of Eucalyptus by Using MODDE Statistical Software

Oxygen Delignification of Kraft Pulp of Whole Stalk Kenaf

The study on Chemi-thermomechanical pulp wastewater treatment using electro-fenton process

Modification on the Chemi-mechanical Pulping Property of Rice Straw with Alkali-urea System

Relationship between the Change in E/T Ratio and the Cooking Performance of Eucalyptus and Acacia Woods during Kraft Pulping Process

Research On Cotton Stalk Pulping With Alkaline Peroxide Extruding Pulp

Deoxylapachol in Tectona grandis wood as a catalyst for delignification and carbohydrate protection during the kraft cooking of eucalyptus wood

Optimization of Batch Cooking Parameters Based on SVM and Genetic Algorithm

Effect of chemical composition and wood property on kraft pulping of eucalyptus

Preparation of Eucalyptus pulp by mild condition of low-temperature, atmospheric pressure, and short-reaction-time with high-boiling-point solvent and pulp properties

Combination of steam explosion and laccase-mediator treatments prior to Eucalyptus globulus kraft pulping

Comparative Evaluation Of Organic Acid Pretreatment Of Eucalyptus For Kraft Dissolving Pulp Production

Addition of green and black liquor in kraft pulping of Eucalyptus dunnii wood: possible solutions for the problems with kraft pulping caused by high calcium content

Influences of 2-ethylanthraquinone on lignin degradation in alkaline cooking of Eucalyptus pellita wood

Methanol Formation During Pulping

Kraft cooking of birch wood chips: differences between the dissolved organic material in pore and bulk liquor

Delignification Reaction Course of Poplar Kraft Pulping with Green Liquor Pretreatment

Application of Alkaline Ionic Liquids in the Pretreatment Process of Eucalyptus Kraft Pulping

Monitoring the kappa number of bleached pulps based on FT-Raman spectroscopy

A low-energy and sustainable pulping technology for eucalypts slabs using deep eutectic solvent

Optimization of Integrated Electrochemical Oxidation and Biodegradation (EO‐BD) for Kraft Lignin