Abstract:Carbon nanotubes (CNTs) are considered an advanced form of carbon. They have superior characteristics in terms of mechanical and thermal properties compared to other available fibers and can be used in various applications, such as supercapacitors, sensors, and artificial muscles. The properties of single-walled carbon nanotubes (SWNTs) are significantly affected by geometric parameters such as chirality and aspect ratio, and testing conditions such as temperature and strain rate. In this study, the effects of geometric parameters and temperature on the mechanical properties of SWNTs were studied by molecular dynamics (MD) simulations using the Large-scaled Atomic/Molecular Massively Parallel Simulator (LAMMPS). Based on the second-generation reactive empirical bond order (REBO) potential, SWNTs of different diameters were tested in tension and compression under different strain rates and temperatures to understand their effects on the mechanical behavior of SWNTs. It was observed that the Young’s modulus and the tensile strength decreases with increasing SWNT tube diameter. As the chiral angle increases, the tensile strength increases, while the Young’s modulus decreases. The simulations were repeated at different temperatures of 300 K, 900 K, 1500 K, 2100 K and different strain rates of 1 × 10−3/ps, 0.75 × 10−3/ps, 0.5 × 10−3/ps, and 0.25 × 10−3/ps to investigate the effects of temperature and strain rate, respectively. The results show that the ultimate tensile strength of SWNTs increases with increasing strain rate. It is also seen that when SWNTs were stretched at higher temperatures, they failed at lower stresses and strains. The compressive behavior results indicate that SWNTs tend to buckle under lower stresses and strains than those under tensile stress. The simulation results were validated by and consistent with previous studies. The presented approach can be applied to investigate the properties of other advanced materials.

Tight binding method simulation of the formation of nanotube

Molecular Dynamics Simulation of Chiral Carbon Nanothread Bundles for Nanofiber Applications

Coupled Thermomechanics Of Single-Wall Carbon Nanotubes

(Invited) Physics and Applications of Spontaneously Aligned Macroscopic Nanotube Assemblies

Direct evidence for lip-lip interactions in multi-walled carbon nanotubes

Interfacial Thermal Conductance of Buckling Carbon Nanotubes

Molecular Dynamics Simulations of the Morphology Transformations in Unzipped Carbon Nanotubes

Competition Between the Intratube Curvature and Intertube Coupling Effects in Carbon Nanotube Bundles

Mechanical and Thermal Properties of Graphyne-Coated Carbon Nanotubes: a Molecular Dynamics Simulation on One-Dimensional All-Carbon Van Der Waals Heterostructures

Molecular Dynamics Simulation of Motion of Single-Walled Carbon Nanotubes on Graphite Substrate

A Possible Formation Mechanism of Double-Walled and Multi-Walled Carbon Nanotube: A Molecular Dynamics Study

Ultrahigh Convergent Thermal Conductivity of Carbon Nanotubes from Comprehensive Atomistic Modeling

Two Distinct Buckling Modes In Carbon Nanotube Bending

Helicity and inter-tube bonding in bundles of single-walled carbon nanotubes

Formation of nanoribbons by carbon atoms confined in a single-walled carbon nanotube -- A molecular dynamics study

Molecular Dynamics Simulations of Thermal Transport of Carbon Nanotube Interfaces

Spontaneously Formed Closed Rings of Single-Wall Carbon Nanotube Bundles and Their Physical Mechanism

Temperature-induced reversal effects of kink dynamics in carbon nanotube on flat substrate

Molecular Dynamics Simulations of Effects of Geometric Parameters and Temperature on Mechanical Properties of Single-Walled Carbon Nanotubes

Ab Initio Molecular Dynamics Study on Small Carbon Nanotubes

Atomistic Failure Mechanism of Single Wall Carbon Nanotubes with Small Diameters