Abstract:Bamboo-concrete composite (BCC) beams are newly-innovated products used for floor system which synergistically utilizes bamboo and concrete components. These composite beams at cur-rent technology belong to the beam characterized with partial composite action due to the ex-istence of relative slip between bamboo segment and concrete slab. Existing investigations have demonstrated that the load bearing capacity of BCC beams depends on their bending stiffness; however, very limited prediction models are available to accurately estimate the bending stiffness of BCC beams. At present, the bending stiffness of BCC beams is predicted with the help of gamma-method in Eurocode 5-Part 1-1, and available studies have demonstrated that this method overestimates the bending stiffness of BCC beams. To this end, this paper presents a novel explicit model characterized with mechanism and data mining to predict the bending stiffness of BCC beams under short-term loads. Three steps were performed to achieve the aforementioned research objective. The first step was to introduce the axial force transfer coefficient into the equilibrium equations of internal force for bamboo segment and concrete slab. Secondly, the bending stiffness of BCC beams was established by taking into account the effect of relative slip with the help of existing experimental results from the interfacial shear test and flexural test. Finally, the proposed model was validated by comparing with flexural performance results of BCC beams collected from available literature as well as those obtained from gamma-method. The comparative results show that: i) the predicted bending stiffness of BCC beams is much closer to tested ones compared with gamma-method; ii) the errors of proposed model predicting the bending stiffness for most BCC beams are within 10% of test results; however, nearly half of the predicted ones using gamma-method have errors exceeding 10% of test results, both of which verify that the mechanism and data mining-dual driven model receives a better prediction for short-term bending stiffness of BCC beams.

Accurate predictions of bending deflections for soft-core sandwich beams subject to concentrated loads

Bending Stiffness of Bamboo-Concrete Composite (BCC) Beams under Short-Term Loads

Analytical Theory of Composite Beams with CSWs Using the State Space Method

Reduced Stiffness of Composite Beams Considering Slip and Shear Deformation of Steel

Critical Load for Shear-Induced Lateral-Distortional Buckling in I-section Steel Beams Considering Flexural Stiffness Ratio

A novel computational framework for exact stress analysis and bending behavior of sandwich panels with non-homogeneous cores

Bending analysis of functionally graded sandwich beams with general boundary conditions using a modified Fourier series method

Bending and Buckling of Circular Sandwich Plates with a Hardened Core

Predicting deflection of retrofitted reinforced concrete beams

Global Buckling Design of Multi-Celled CFST Walls with Four Simply-Supported Edges

Study on Calculation Method of Bending Performance of Concrete Sandwich Composite Slab

Accurate thermomechanical analysis of sandwich beams with nonhomogeneous core by quadrature element method

A new sandwich beam model with layer-to-layer boundary modified displacements based on higher-order absolute nodal coordinate formulation

OPTIMAL DESIGN OF SANDWICH BEAMS WITH LIGHTWEIGHT CORES IN THREE-POINT BENDING

Analysis of deformation and failure mechanism of sandwich beams with lattice core under three-point bending load

A comprehensive investigation on bending stiffness of composite grid-stiffened and functional foams sandwich beam

An efficient approach to investigate the post-buckling behaviors of sandwich structures

Analyses of bending performance of innovative paper-based sandwich beams with cup-box core

Being gradually softened approach for solving large deflection of cantilever beam subjected to distributed and tip loads

Analytical modeling of sandwich beam for piezoelectric bender elements

A nonlinear couple stress-based sandwich beam theory