Abstract:Molecular dynamics (MD) simulations are employed to investigate the capillary fluctuations of steps on the surface of a model metal system. The fluctuation spectrum, characterized by the wave number ($k$) dependence of the mean squared capillary-wave amplitudes and associated relaxation times, is calculated for $\left<110\right>$ and $\left<112\right>$ steps on the $\{111\}$ surface of elemental copper near the melting temperature of the classical potential model considered. Step stiffnesses are derived from the MD results, yielding values from the largest system sizes of $(37\pm1) \, \mathrm{meV}/\mathring{\mathrm{A}}$ for the different line orientations, implying that the stiffness is isotropic within the statistical precision of the calculations. The fluctuation lifetimes are found to vary by approximately four orders of magnitude over the range of wave numbers investigated, displaying a $k$ dependence consistent with kinetics governed by step-edge mediated diffusion. The values for step stiffness derived from these simulations are compared to step free energies for the same system and temperature obtained in a recent MD-based thermodynamic-integration (TI) study [Freitas, Frolov, and Asta, Phys. Rev. B 95, 155444 (2017)]. Results from the capillary-fluctuation analysis and TI calculations yield statistically significant differences that are discussed within the framework of statistical-mechanical theories for configurational contributions to step free energies.

Steps on the Au/Cu(111) Surface Studied by Local Work Function Measurement with STM

Scanning tunneling microscopy measurements of the local work function around steps on the Au/Cu(111) surface

Local Work Function Measurement on Cu(111)-Au and Cu(111)-Pd Surfaces

Variation of the Local Work Function at Steps on Metal Surfaces Studied with Stm

Local Work Function for Cu(111)–Au Surface Studied by Scanning Tunneling Microscopy

LOCAL WORK FUNCTION MEASURED WITH SCANNING TUNNELING MICROSCOPY

Elemental Contrast of Local Work Function Studied by Scanning Tunneling Microscopy

Spatial variation of local work function of the Au/Cu(111) and Pd/Cu(111) systems

The Nature of Surface States on Vicinal Cu (775): An STM and Photoemission Study

Steps Onfe3o4(100): STM Measurements and Theoretical Calculations

Capillary fluctuations of surface steps: An atomistic simulation study for the model Cu(111) system

Scanning Tunneling Microscopy Study of Surface Reconstruction Induced by N Adsorption on Cu（100） Surface

Theoretical Study on the Atomic Structure, Electronic States, and STM Image of C(2×2) Cu(001)/O Surface

The Growth of Size-Determined Cu Clusters in Nanometer Holes on Au(111) Due to A Balance Between Surface and Electrochemical Energy

Step-Edge Decoration and Clustering of Pt Atoms on a Cu(211) Stepped Surface

Manipulating a Co adatom on a stepped Cu surface by an STM tip: A theoretical study

Investigation of Tunneling Current and Local Contact Potential Difference on the TiO2(110) Surface by AFM/KPFM at 78 K

Current-Dependent Periodicities of Si(553)-Au

Scanning Tunneling Microscopy Observation of Electron Standing Waves on Au(111) Film with a Superconducting Tip

Steps of Al/Si nanocluster studied by scanning tunneling microscope Moire method

Local Work Function Measurement on Bi2Sr2CaCu2Oy Single Crystal with STM