Abstract:Cobalt-based nanomaterials have been widely studied as catalysts for the oxygen reduction reaction (ORR) and oxygen evolution reaction (OER) due to their remarkable bifunctional catalytic activity, low cost, and easy availability. However, controversial results concerning OER/ORR performance exist between different types of cobalt-based catalysts, especially for Co(OH)2 and Co3O4. To address this issue, we develop a facile electrochemical deposition method to grow Co(OH)2 directly on the skeleton of carbon cloth, and further Co3O4 was obtained by post thermal treatment. The entire synthesis strategy removes the use of any binders and also avoids the additional preparation process (e.g., transfer and slurry coating) of final electrodes. This leads to a true comparison of the ORR/OER catalytic performance between Co(OH)2 and Co3O4, eliminating uncertainties arising from the electrode preparation procedures. The surface morphologies, microstructures, and electrochemical behaviors of prepared Co(OH)2 and Co3O4 catalysts were systemically investigated by scanning electron microscopy, transmission electron microscopy, atomic force microscopy, and electrochemical characterization methods. The results revealed that the electrochemically deposited Co(OH)2 was in the form of vertically aligned nanosheets with average thickness of about 4.5 nm. After the thermal treatment in an air atmosphere, Co(OH)2 nanosheets were converted into mesoporous Co3O4 nanosheets with remarkably increased electrochemical active surface area (ECSA). Although the ORR/OER activity normalized by the geometric surface area of mesoporous Co3O4 nanosheets is higher than that of Co(OH)2 nanosheets, the performance normalized by the ECSA of the former is lower than that of the latter. Considering the superior apparent overall activity and durability, the Co3O4 catalyst has been further evaluated by integrating it into a Zn-air battery prototype. The Co3O4 nanosheets in situ supported on carbon cloth cathode enable the assembled Zn-air cells with large peak power density of 106.6 mW cm-2, low charge and discharge overpotentials (0.67 V), high discharge rate capability (1.18 V at 20 mA cm-2), and long cycling stability (400 cycles), which are comparable or even superior to the mixture of state-of-the-art Pt/C and RuO2 cathode.

Comparison of Catalytic Performance of Mn_3O_4-loaded Two-dimensional and Tree-dimensional Msoporous Carbon Mterials in Znc-air Bttery

Comparison of catalytic performance of Mn3O4-loaded two-dimensional and tree-dimensional msoporous carbon mterials in zinc-air battery

High Electrocatalytic Performance of Mn<sub>3</sub>O<sub>4</sub>/Mesoporous Carbon Composite for Oxygen Reduction in Alkaline Solutions

Mn3o4 Nanoparticles on Layer-Structured Ti3c2 Mxene Towards the Oxygen Reduction Reaction and Zinc-Air Batteries

Dual-Carbon Assisted Oxygen Vacancy Engineering for Optimizing Mn(III) Sites to Enhance Zn-air Battery Performances

Controllable syntheses of composite catalysts Co3O4/(δ-, β-) MnO2 and α-MnO2 as oxygen reduction catalyst for zinc-air battery

Manganese Oxide/Mesoporous Carbon Spherical Composite:Study on Its Enhanced Catalytic and Electrochemical Performance

Comparative study of the performance of α-MnO2 and amorphous manganese dioxide air electrodes for zinc-air batteries

Preparation and Study of Zinc-Air Batteries with Carbon-Supported Amorphous Mno2 Catalyst

A Comparison Study of MnO2 and Mn2O3 As Zinc-Ion Battery Cathodes: an Experimental and Computational Investigation

MnF2 Surface Modulated Hollow Carbon Nanorods on Porous Carbon Nanofibers as Efficient Bi‐Functional Oxygen Catalysis for Rechargeable Zinc–Air Batteries

Three‐Dimensional Conductive Interface and Tip Structure of MnO2 Electrode Facilitate Superior Zinc Ion Batteries

3D N-doped ordered mesoporous carbon supported single-atom Fe-N-C catalysts with superior performance for oxygen reduction reaction and zinc-air battery

Mno@1-D Carbon Composites from the Precursor C4h4mno6 and Their High-Performance in Lithium Batteries

Reconciling Mass Loading and Gravimetric Performance of MnO2 Cathodes by 3D‐Printed Carbon Structures for Zinc‐Ion Batteries

Clarifying the Controversial Catalytic Performance of Co(OH)2 and Co3O4 for Oxygen Reduction/Evolution Reactions toward Efficient Zn-Air Batteries

Nanoconfined Nitrogen-Doped Carbon-Coated MnO Nanoparticles in Graphene Enabling High Performance for Lithium-Ion Batteries and Oxygen Reduction Reaction

In Situ Coupling of MnO and Co@N-Doped Graphite Carbon Derived from Prussian Blue Analogous Achieves High-Performance Reversible Oxygen Electrocatalysis for Zn-Air Batteries

A New High-Performance Porous Carbon-Coated Mn3O4/Na2CO3 Cathode for Suppressing Mn2+Dissolution in Aqueous Zinc Ion Batteries.

Atomically Dispersed Mn Within Carbon Frameworks As High-Performance Oxygen Reduction Electrocatalysts for Zinc-Air Battery

Porous Calcium-Manganese Oxide/Carbon Nanotube Microspheres As Efficient Oxygen Reduction Catalysts For Rechargeable Zinc-Air Batteries