Abstract:Conventional active control of road noise inside a vehicle cabin generally uses a pure feedforward control system with the conventional filtered-x least mean square (FXLMS) algorithm. While it can yield satisfactory noise reduction when the reference signal is well correlated with the targeted noise, in practice, it is not always possible to obtain a reference signal that is highly coherent with a broadband response typically seen in road noise. To address this problem, an active noise control (ANC) system with a combined feedforward–feedback controller is proposed to improve the performance of attenuating road noise. To take full advantage of the feedforward control, a subband (SFXLMS) algorithm, which can achieve more noise attenuation over a broad frequency range, is used to replace the conventional FXLMS algorithm. Meanwhile, a feedback controller, based on internal model control (IMC) architecture, is introduced to reduce the road noise components that have strong response but are poorly correlated with the reference signals. The proposed combined feedforward–feedback ANC system has been demonstrated by a simulation model with six reference accelerometers, two control loudspeakers and one error microphone, using actual data measured from a test vehicle. Results show that the performance of the proposed combined controller is significantly better than using either a feedforward controller only or a feedback controller only, and is able to achieve about 4 dBA of overall sound pressure level reduction.

Active Control of One-Dimension Impulsive Reflection Based on a Prediction Method.

Active Control of Three-Dimension Impulsive Scattered Radiation Based on a Prediction Method

Active Control on the Scattered Radiation by a Rigid Surface

A Method of Sound Field Control Using Beam Deflection

Unidirectional Acoustic Boundary Through Active Control System in One Dimensional Duct

Feedforward Active Noise Global Control Using a Linearly Constrained Beamforming Approach

Estimation and global control of noise reflections

Progress of research on active noise radiation control with reflecting surfaces

Performance of a Multichannel Active Sound Radiation Control System Near a Reflecting Surface

An Active Noise Control System Based on Soundfield Interpolation Using a Physics-informed Neural Network

Effect Of A Reflecting Surface On The Global Power Reduction Performance Of Multichannel Anc Systems

Development of active noise control simulation with virtual controller based on computational aeroacoustics

A Feedback Active Control Approach to Road Noise Based on a Single Microphone Sensor to Improve Automotive Cabin Sound Comfort

Effect of reflecting surfaces on the performance of active noise control

A directional active noise control algorithm based on all-pass/minimum phase decomposition

Combined Feedforward–Feedback Active Control of Road Noise Inside a Vehicle Cabin

An Improved Active Noise Control Algorithm Without Secondary Path Identification Based on the Frequency-Domain Subband Architecture

Increasing the Performance of Active Noise Control Systems on Ground with Two Vertical Reflecting Surfaces with an Included Angle

An Analysis of a Feedback Active Noise Control System Using the Remote Microphone Technique

Spatial Active Noise Control Method Based On Sound Field Interpolation From Reference Microphone Signals

Deep learning-assisted active noise control in a time-varying environment