An Experimental and Chemical Kinetic Modeling Study of 1,3-Butadiene Combustion: Ignition Delay Time and Laminar Flame Speed Measurements
Chong-Wen Zhou,Yang Li,Ultan Burke,Colin Banyon,Kieran P. Somers,Shuiting Ding,Saadat Khan,Joshua W. Hargis,Travis Sikes,Olivier Mathieu,Eric L. Petersen,Mohammed AlAbbad,Aamir Farooq,Youshun Pan,Yingjia Zhang,Zuohua Huang,Joseph Lopez,Zachary Loparo,Subith S. Vasu,Henry J. Curran
DOI: https://doi.org/10.1016/j.combustflame.2018.08.006
IF: 4.4
2018-01-01
Combustion and Flame
Abstract:Ignition delay times for 1,3-butadiene oxidation were measured in five different shock tubes and in a rapid compression machine (RCM) at thermodynamic conditions relevant to practical combustors. The ignition delay times were measured at equivalence ratios of 0.5, 1.0, and 2.0 in 'air' at pressures of 10, 20 and 40 atm in both the shock tubes and in the RCM. Additional measurements were made at equivalence ratios of 0.3, 0.5, 1.0 and 2.0 in argon, at pressures of 1, 2 and 4 atm in a number of different shock tubes. Laminar flame speeds were measured at unburnt temperatures of 295 K, 359 K and 399 K at atmospheric pressure in the equivalence ratio range of 0.6-1.7, and at a pressure of 5 atm at equivalence ratios in the range 0.6-1.4. These experimental data were then used as validation targets for a newly developed detailed chemical kinetic mechanism for 1,3-butadiene oxidation. A detailed chemical kinetic mechanism (AramcoMech 3.0) has been developed to describe the combustion of 1,3-butadiene and is validated by a comparison of simulation results to the new experimental measurements. Important reaction classes highlighted via sensitivity analyses at different temperatures include: (a) (O) over dotH radical addition to the double bonds on 1,3-butadiene and their subsequent reactions. The branching ratio for addition to the terminal and central double bonds is important in determining the reactivity at low-temperatures. The alcohol-alkene radical adducts that are subsequently formed can either react with HO2 radicals in the case of the resonantly stabilized radicals or O-2 for other radicals. (b) H(O) over dot(2) radical addition to the double bonds in 1,3-butadiene and their subsequent reactions. This reaction class is very important in determining the fuel reactivity at low and intermediate temperatures (600-900 K). Four possible addition reactions have been considered. (c) O-3 atom addition to the double bonds in 1,3-butadiene is very important in determining fuel reactivity at intermediate to high temperatures (> 800 K). In this reaction class, the formation of two stable molecules, namely CH2O + allene, inhibits reactivity whereas the formation of two radicals, namely C2H3 and CH2CHO, promotes reactivity. (d) H atom addition to the double bonds in 1,3-butadiene is very important in the prediction of laminar flame speeds. The formation of ethylene and a vinyl radical promotes reactivity and it is competitive with H atom abstraction by H atoms from 1,3-butadiene to form the resonantly stabilized C4H5-i radical and H-2 which inhibits reactivity. Ab initio chemical kinetics calculations were carried out to determine the thermochemistry properties and rate constants for some of the important species and reactions involved in the model development. The present model is a decent first model that captures most of the high-temperature IDTs and flame speeds quite well, but there is room for considerable improvement especially for the lower temperature chemistry before a robust model is developed. (C) 2018 The Combustion Institute. Published by Elsevier Inc. All rights reserved.