Abstract:have been based either on a differential two point method or the well known four point method [1, 2]. In this report we present the first steps in the development of a contactless, radio-frequency measurement method similar to those discussed in [3, 4]. This method is expected to provide for better spatial resolution and signal to noise ratio. A possible target design for such measurements involves a dielectric capillary surrounded by one or two coils (in this case a coil acts as transmitter and the other as receiver) and a wire shaped target along its axis. The wire target is heated by the ion beam and expands to finally hit the inner wall of the capillary. The conductivity of the layer which builds up at the capillary is then measured through induced eddy currents. To better understand such target assemblies and optimize the experimental setup, several simulations have been performed with the CST Microwave Studio code. The simulated distribution of the electrical current density induced in a conductive layer at the inner wall of the capillary is shown in Fig. 1. The good localisation of the eddy currents in the proximity of the coil is revealed in this image. The simulations also showed that the reflection at the transmitter coil delivers better signals than the receiver coil. Therefore the first tests have been performed with a single coil. The first proof of principle experiment has been performed during the december 2006 HHT beam time. The experimental setup consisted of a signal generator which delivered a 4 ns FWHM quasi-gaussian pulse, a signal splitter, a 300 MHz oscilloscope and the target assembly, all connected by 50 Ω coaxial cables. The target assembly included a 3 mm long quartz capillary with a diameter of 1 mm and a wall thickness of 0.1 mm, and a fivewinding coil made of 0.1 mm copper wire. The target has been a 4 mm long lead wire with a diameter of 0.25 mm. The 2·10 ions intense uranium beam has been delivered in short pulses of about 100 ns FWHM duration and focused down to about 0.5 mm x 0.4 mm at the target. One of the recorded signals is presented in Fig. 2 together with the fourier transforms of the signals reflected from the coil before and during the experimental shot. The

Non-contact electrical conductivity measurements of heavy ion driven warm dense matter

Development of a non-contact electrical conductivity measurement technique for heavy ion driven warm dense matter

DC electrical conductivity measurements of warm dense matter using ultrafast THz radiation

Electrical Conductivity of Noble Gas Plasmas in the Warm Dense Matter Regime

First contactless electrical resistivity measurements for HEDP experiments with heavy ion beams

Measurements of Electrical Resistivity of Heavy Ion Beam Produced High Energy Density Matter: Latest Results for Lead and Tungsten

Electric conductivity of hot and dense nuclear matter

Overwew Of Warm-Dense-Matter Experiments With Intense Heavy Ion Beams At Gsi-Darmstadt

Observation of the electromagnetic field effect via charge-dependent directed flow in heavy-ion collisions at the Relativistic Heavy Ion Collider

Study of experimental method for warm dense matter ionization distribution based on x-ray fluorescence spectroscopy

Very-High-Energy Heavy Ion Beam Dosimetry using Solid State Detectors for Electronics Testing

Dense Nuclear Matter Equation of State from Heavy-Ion Collisions

Warm Dense Matter Research at HIAF

Electrical Conductivity of Warm Dense Hydrogen from Ohm's Law and Time-Dependent Density Functional Theory

Heavy meson tomography of cold nuclear matter at the electron-ion collider

Study of experimental method for warm dense matter onization distribution based on x-ray fluorescence pectroscopy

A fast 6-channel pyrometer for temperature measurement of HED matter generated by intense heavy ion beams

Thermal Conductivity Measurements of Proton-Heated Warm Dense Aluminum.

Studies of High Energy Density in Matter Driven by Heavy Ion Beams in Solid Targets

Toward Quasi-Dc Conductivity of Warm Dense Matter Measured by Single-Shot Terahertz Spectroscopy.