Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Heat-Transfer Performance-Test Of A Prototype Plate-Fin Condenser-Boiler For Industrial Usage

The Research On Condensing And Boiling Heat Transfer In A New Type Plate-Fine Condenser-Evaporator

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Experimental Investigation of High-Temperature Water Flow Boiling Characteristics in Plate-Fin Heat Exchanger for Nuclear Cooling

An Experiment and Simulation Study on Performance of Finned Tube Condenser

Testing System of Heat Transfer Performance in Tube

Design of a high temperature refrigerant condensing heat exchange test bed

Experimental thermohydraulic characterisation of flow boiling and condensation in additive manufactured plate-fin heat exchanger

Performance Tests on a Novel Un-Finned Thermosyphon Heat Exchanger Requiring Single Charge

Experimental Study on Thermal–hydraulic Performance of Moist Air Inside Flat Tube of Two Kinds of Plate-Fin Heat Exchangers

Study of flow and heat transfer performance of plate-fin heat exchanger

Experimental Study on Flow and Heat Transfer Performance of Condensing Gas-Fired Boiler

Experimental Study on Heat Transfer Characteristics of A Condenser in the Presence of Air

Experimental Investigation of Loop Heat Pipe with Novel Interlaced Microchannel Condenser

Boiling Heat Transfer Enhancement Of Liquid Nitrogen In A Tube Condenser-Boiler With Lunate Channels

Experimental Investigation on Flow and Heat Transfer Performance of a Novel Heat Fin-Plate Radiator for Electronic Cooling

Experimental Research on Air Conditioner Prototype with 6-pass Microchannel Condenser

Heat Transfer and Flow Friction Characteristics of a Compact Plate-Type Condenser

Experimental Study Of Water Cooled Condenser Made Of Three Dimensional And High Fin Density Integral-Finned Tubes

Study on the heat transfer characteristics of a plate-fin-typed precooler considering cooling fluid phase change

EXPERIMENTAL INVESTIGATION ON HEAT AND MASS TRANSFER OF PLATE EVAPORATIVE CONDENSER