Abstract:The preparation of high-efficiency and low-cost adsorbents for the defluoridation of drinking water remains a huge challenge. In this study, single-layer and multi-layer boehmite were first synthesized via an organicfree method, and active alumina used for fluoride removal from water was obtained from the boehmite. The advantage of a single layer is that more aluminum is exposed to the surface, which can provide more adsorption sites for fluoride. The active alumina adsorbent derived from single-layer boehmite exhibits a high specific surface area and excellent adsorption capacity. The high surface area ensures a high adsorption capacity, and the organic-free synthesis method lowers the preparation cost. The asprepared adsorbent was characterized by X-ray powder diffraction (XRD), scanning electron microscopy (SEM), high-resolution transmission electron microscopy (HRTEM), Fourier-transform infrared spectroscopy (FTIR) and nitrogen adsorption-desorption analysis. The single-layer structure of boehmite was determined from the simulated XRD diffraction pattern of single-layer boehmite. The disappearance of the (020) diffraction peak of boehmite illustrates that the dimensions in the b direction are extremely small, and according to the XRD simulation results, the single-layer structure of boehmite could be determined. Single-layer boehmite with a surface area of 789.4 m(2).g(-1) was formed first. The active alumina obtained from the boehmite had a surface area of 678.4 m(2).g(-1), and the pore volume was 3.20 cm(3).g(-1). The fluoride adsorption of the active alumina was systematically studied as a function of the adsorbent dosage, contact time, concentration, co-existing anions, and pH. The fluoride adsorption capacity of the active alumina obtained from the single-layer boehmite reached up to 67.6 mg.g-1, which is higher than those of most alumina adsorbents reported in the literature. The adsorption capacities of the active alumina are related to the specific surface area and the number of hydroxyl groups on the surface. Dosages of 0.6, 1.0, and 2.6 g.L-1 of active alumina were able to lower the 10, 20, and 50 mg.L-1 fluoride solutions, respectively, below the maximum permissible limit of fluoride in drinking water in China (1.0 mg.L-1), suggesting that the active alumina synthesized in this work is a promising adsorbent for defluoridation of drinking water. In addition, the fluoride adsorption is applicable in a wide pH range from 4 to 9 and is mainly interfered by SO42- and PO43-. Further investigation suggested that the fluoride adsorption of the active alumina follows the pseudo second-order model and Langmuir isotherm model.

Experimental Study on Defluoridation to Low ConcentrationGroundwater Using Diatomite

Experimental Study on Defluoridation of Low Concentration Groundwater Using Nano-Molecular Sieve

Removal of Fluoride from Geothermal Water by Waste-Synthesized Al(OH)3-HAP@ZMS Composite Adsorbent: Sorption Capability and Mechanism

Adsorption Characteristics and Charge Transfer Kinetics of Fluoride in Water by Different Adsorbents

Purification and Carbonation for High Loss and Low-Grade Diatomite in Inner Mongolia

Preparation of aluminium-hydroxide-modified diatomite and its fluoride adsorption mechanism

Defluoridation of Drinking Water by Mg/Al Hydrotalcite-Like Compounds and Their Calcined Products

A Novel Method for Purification of Low Grade Diatomite Powders in Centrifugal Fields

Defluoridation of Drinking Water Using Electrocoagulation-Microfiltration

INFLUENCE OF PROPERTY-MODIFICATION OF DIATOMITE ON REMOVING FLUORINE IN INDUSTRIAL WASTEWATER

The Effect and Potential Mechanism of Cement-Based Pellets for Fluoride Removal from Surface Water

Experimental and DFT calculation study on the efficient removal of high fluoride wastewater from metallurgical wastewater by kaolinite

Defluoridation Of Water Using Active Alumina Derived From Single-Layer Boehmite

Defluoridation Properties of Aluminum Impregnated Bone Charcoal Adsorbent

Adsorption of Fluoride from Aqueous Solution Using Low-Cost Bentonite/Chitosan Beads

Defluoridation by Freshly Prepared Aluminum Hydroxides

Characterization and performance of novel carbon-doped aluminum-modified bentonite for cost-effective fluoride removal

Adsorption characterization and mechanism of aluminum based chitosan/zeolite molecular sieve composite for fluoride removal

Research on Advanced Treatment Technology of Fluorine Containing Wastewater from Graphite Production

Al-1,3,5-benzenetricarboxylic metal–organic frameworks: A promising adsorbent for defluoridation of water with pH insensitivity and low aluminum residual

An Experimental Study of Fluoride Removal from Wastewater by Mn-Ti Modified Zeolite