Abstract:This article presents a 17.720.2 GHz eight-element four-beam RF-beamforming transmitter in 65-nm CMOS for satellite communication (SATCOM). The transmitter utilizes an analog scheme in the variable-gain amplifier (VGA) to achieve dB-in-linear gain control with a high dynamic range (DR), together with a current combining crossbar for a compact footprint. The vector-modulation-based (VM-based) phase shifter (PS) adopts the cancellation-based $G_\mathrm{m}$ units for low switching variation. Furthermore, eight PSs of each beam are split into two groups, with each group sharing the same tunable I/Q generator for low power consumption. Considering the increased peak-to-average power ratio (PAPR) caused by high-order modulation schemes and multibeam operation, the transmitter incorporates compact transformer-based Doherty power amplifiers (DPAs) with adaptive bias control to improve the power efficiency at back-off. The chip achieves a 31-dB gain-tuning range with a 0.283-dB step and a 360 $^{\circ}$ phase-shifting range with a calibrated 7-bit resolution. The measured root-mean-square (RMS) phase/gain errors induced by the VGA/PS are below 2.05 $^{\circ}$ /0.147 dB, respectively, which decouples phase/gain control. The transmitter achieves a maximum output 1-dB gain compression point (OP $_{\mathrm{1 dB}}$ ) of 17.9 dBm and a maximum saturated power ( $P_{\mathrm{sat}}$ ) of 18.9 dBm. The output element exhibits 29.3% drain efficiency (DE) at 6-dB power back off (PBO) from $P_{\mathrm{sat}}$ , which is 1.56/3.12 times over the normalized class-B/class-A implementations, demonstrating Doherty PBO efficiency enhancement. The chip occupies an area of 8.59 $\times$ 4.17 mm $^2$ and consumes 398 mW per element at OP $_{\mathrm{1~dB}}$ . Additionally, a 16-element linear array has been developed to showcase the capabilities of the multibeam operation and gain tapering.

A Four-Channel Beamforming Down-Converter in 90-Nm CMOS Utilizing Phase-Oversampling.

A $K$-Band Four-Beam Transmitter with Decoupled Phase/Gain Control and Enhanced Power Back off Efficiency for SATCOM

A Hybrid Beamforming Receiver with Two-Stage Analog Combining and Low-Resolution ADCs

A Four-Element 7.5–9-Ghz Phased-Array Receiver with 1–8 Simultaneously Reconfigurable Beams in 65-Nm CMOS

A Ka-band 8-Element 4-Beam Transmitter Front End with Hybrid VGA and Symmetrical Transformer-based Doherty PA

An Inherently Linear Phase-Oversampling Vector Modulator in 90-Nm CMOS

A 4-Element 7.5-9 GHz Phased Array Receiver with 8 Simultaneously Reconfigurable Beams in 65 Nm CMOS Technology

A Ka-Band 64-Element Four-Beam Phased Array Receiver with Inter-Beam Interference Cancellation

A Broadband Bidirectional Four-Element Four-Beam Beamformer with Compact Floorplan in a 65nm CMOS Technology

A K-Band 4-Element 8-Beam Phased-Array Receiver with Hybrid Vector Interpolation and Impedance-Adapted Multibeam Combining Techniques for Satellite Communications

An Ultra Broadband Passive Vector Modulator Phase Shifter

Radio Frequency Beamforming Based on a Complex Domain Frontend

Multiphase Interpolating Digital Power Amplifiers for TX Beamforming

A 4-Element 60-Ghz CMOS Phased-Array Receiver with Transformer-Based Hybrid-Mode Mixing and Closed-Loop Beam-Forming Calibration

A 2.1–2.5 GHz high linearity and low noise down-conversion active mixer

A 4-Element Ka-Band Phased-Array Receiver with Code-Domain Hybrid Beamforming

Orbital Angular Momentum Mode-Group Beamforming System Based on an Integrated Optical True Time Delay Line Chip

Two-Timescale Hybrid Analog-Digital Beamforming for Mmwave Full-Duplex MIMO Multiple-Relay Aided Systems

A 28-GHz Four-Channel Beamforming Front-End IC With Dual-Vector Variable Gain Phase Shifters for 64-Element Phased Array Antenna Module